answersLogoWhite

0

my gas gauge doesnt work and i dont get a warning light when about to run out, mine goes to fuel when its about to run out

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Why is your temp gauge not working?

i change the thermostat and the temp switch but still not working


How do you know if airbags of 2001 Mercedes Benz e-series is still working. light indicator is yellow?

Go to a some electro servicw specialised for MBenz and they will check your system


Why does the hot surface indicator light stay on?

The hot surface indicator light stays on to alert you that the surface is still hot and may cause burns or other hazards.


Temperature gauge still not working on 1998 Ford Explorer after new sending unit installed. It goes to hot if I ground it out.?

Be sure you are replacing the temp sending unit for a gauge application. The parts counter person may have given you one for an idiot light.


Is a flashlight a source of light?

If it is working and produces light, then it is a source of light.


If a plug socket is left on with nothing pluged in will it still consume power?

No, unless there is an indicator light in the socket.


Will a gas light work if the gas gauge doesn't work?

on some vehicles the gas light will still work if the gauge does not. on some vehicles such as an 1985 Toyota cressida have a separate sensor allowing the low fuel light to illuminate.


98 ranger replaced alternator and battery but still shows battery light and no charge on gauge?

sounds like your gauge is broken or there is a short in wiring


Which fuse disconnects the TPMS indicator dash light on your 2007 Sonata?

even iff the system is fused the light on the dash will still stay on best way to get the light to go out is to have the problem fixed


Why when your temperature gauge stops working does my AC also stop working?

No ur AC should still work it may just be that your gauge is jammed and just needs to be loosened take it to the nearest garage as you dont want any overheating of the car or it will costs you $$$


How do you reset the service indicator light on a 2001 Mercury Cougar after changing the oil?

To reset the light,hold the SELECT and UNITS buttons for 5 seconds.The service interval light will be illuminated and then extinguish after approximately 4 seconds.


Why is it important to have an indicate light on a surge suppressor for your computer?

Answer Most of the surge suppressor indicator lights only show if the power is present and turned on. It does not add any other functionality in terms of surge suppression. Only if a particular model indicator shows that there was a surge on power line, it makes it more useful for the user as person can investigate reason or surge if it is happening repeatedly. Iindicator should be clearable manually by user. - Neeraj Sharma "...it's important a surge supressor has a light indicator that says the supressor part of the device is still working. Otherwise, you might not have protection" A+ Guide to Managing & Maintaining your PC (page 161) -MonkGizmo That indicator light cannot report all failures. Normal failure mode for a protector is to degrade. That light cannot report a degraded protector. That light only reports that a surge, much too large for the protector, caused its thermal fuse to disconnect protector parts as fast as possible. To avert a fire. That light can only report a type of failure that says a protector was grossly undersized. And a potential threat to human life if that fuse did not blow fast enough.