answersLogoWhite

0

It's not advisable to put washable marker on a light bulb. The heat generated by the bulb can cause the ink to melt or produce fumes, which could be harmful. Additionally, the marker may not adhere well to the glass surface, leading to smudging or removal. For safety and effectiveness, consider using alternative methods for decorating or labeling.

User Avatar

AnswerBot

2mo ago

What else can I help you with?

Related Questions

How do you replace the side marker bulb in a 2005 Mercedes C230?

its easy just put a liitle of preasure on marker light push forward . it should come out. do the reverse to put back on after replacing bulb.


If you are at a sleepover and someone does a trick on you what do you do back?

put their bra and underwear in the freezer and when they r asleep write on their face with washable marker!


What are some pranks about drawwing something on someones feet and then put their socks on while they are still sleeping?

Draw a penis with sharpie. Or washable marker in black.


How do you replace side marker bulb on 2002 Buick Lesabre?

The side marker bulbs on a 2002 Buick LeSabre are replaced by removing the retaining screws and disconnecting the wiring harness. The old bulb can then be removed and a new bulb put in its place.


How do you put energy of light in light bulb?

electricity


How do you change marker lights on 2001 neon?

there are to 5/16th bolts that hold your head light on .open the hood remove the to bolts and there is on that ties the light fixture into the center of the grill then remove the light undo your bulb put in sa new one then put it all back togather drive safe


How do you replace marker lights on a 2008 gmc Yukon Denali?

You can replace the marker lights on a 2008 GMC Yukon Denali by removing the retaining screws and disconnecting the wiring harness. The bulb can then be unscrewed and a new bulb put in place.


Does a light bulb affect water?

Not really, but the light bulb might not work if it's on and you put it in water.


How do you replace a fog light bulb in 1993 300zx?

remove the side marker light assy Phillips screws, the assy will slide out. you then have access to the three 10mm bolts holding the fog light assy in. remove then and push out the fog light assy. then remove the four Phillips screws from the corners of the fog light to separate the assy. then change the bulb and put back together


How do you install a side marker light on a 1994 buick century?

To install a front marker light, open the hood and look down in the corner next to the headlight. You should see a little silver colored wire with a loop on the end. Pull on the loop and remove it the the lip it rests on. The front parking light/side marker light comes off by pulling the unit forward from outside the car. It may be stuck but it will come off without breaking it. Be sure to put the silver wire back on the lip after changing the bulb. You do that by pulling on the wire loop. This is the only thing that holds the unit on the car. The side marker light is the small bulb on the side. I think the bulb number is 194. The factory one is amber but a clear will work as the side part of the lens is amber. .


How many orange does it take to light a light bulb?

None! as Oranges can't either put up nor light an light bulb! ;)


Is an light bulb charge of electricity?

Well if you brought a light bulb friom a shop then no but when you put the light bulb in the the thing on where it goes then yes it does because the light is on the you are going down on your power