answersLogoWhite

0

This depends on if the glass is tempered or not. Usually tempered glass is more solid, but also more fragile. You see this glass in fish tanks alot, and its the glass with a little more clarity. The other type of glass is more durable, but a little less clear. This is in cars. You can sand untempered glass.

Edges can be abraded with a fine diamond file, in one direction only. And gently, please , with the glass evenly supported.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

How many cuting edges does sand have?

sand has many cutting edge


Is a mirror made out of sand?

No, a mirror is typically made out of glass with a reflective coating applied to the back surface. Sand is not translucent or reflective enough to function as a mirror.


Is there sand under the Antarctica surface?

Sand is not common in Antarctica, even at the edges of the continent.


What you use to smooth the rough edges?

sand paper


How many cutting edges does a grain of sand have?

57


HOW DO sand edges on plate glass?

To sand edges on plate glass, you can use sandpaper with a fine grit to carefully remove any sharp edges and smooth them out. Make sure to wear safety gloves and goggles to avoid any injuries during the sanding process. Sand in a gentle, circular motion until the edges are smooth to the touch.


Mirror of twilight in Zelda?

on top of sand timple


How was a mirror made?

silicon sand from sri lanka or japan.


How much topsoil should be layered over sand in order to successfully grow grass?

A layer of at least 6 inches of topsoil should be layered over sand to successfully grow grass.


How many cutting edges are in a grain of sand?

If the grain is rounded, none.


How do you change a square table to round table?

sand off the edges


How can I achieve a seamless molding around a mirror?

To achieve a seamless molding around a mirror, you can use a miter saw to cut precise angles on the molding pieces. Make sure the corners fit together tightly and use a strong adhesive to secure the molding in place. Sand down any rough edges for a smooth finish.