0
What else can I help you with?
What makes the string cut on a hay baler?
A blade cuts the twine as it finishes wrapping
How does a hay baler work?
hay is picked up by a the pickup tines, then pushed perpendicularly by a "fork". it is then compacted into slabs by the plunger and tied with twine by the knotters. the bale then comes out the back of the baler.
How do you replace the twine on welger ap 45hay baler?
To replace the twine on a Welger AP 45 hay baler, first, ensure the baler is turned off and disconnect the power source for safety. Open the twine box and remove any remaining twine from the spools. Load the new twine onto the spools, threading it through the designated guides and tensioners as outlined in the user manual. Finally, secure the twine in place and test the baler to ensure proper operation.
How do you thread a 270 hay baler?
To thread a 270 hay baler, first, ensure the baler is properly set up and the twine is loaded onto the spool. Pull the twine from the spool and guide it through the tensioner and around the bale chamber, following the specific threading path indicated in the owner's manual. Make sure to secure the twine in the appropriate clamps or guides to ensure it feeds correctly during operation. Finally, test the mechanism to ensure the twine is properly threaded and ready for baling.
How does a hay baler knot?
A hay baler knots bales using twine or wire by employing a mechanism that feeds the material through a series of rollers and tensioning devices. Once the desired bale size is achieved, the baler automatically wraps the twine around the bale, then uses a knotting system that typically involves a series of hooks and blades to securely tie the twine in a knot. This process ensures that the bales are tightly bound for easier handling and storage. The knotting system is designed to be efficient, allowing for rapid production of bales during the harvesting process.
How do you make a hay flake?
How do you make a hay flake??? A hay flake is a section of hay that freely breaks apart from the bale after you cut the twine. Soooo, I uess my answer would be- bale the hay and then cut the twine and remove the flake! Ta Da..... a hay flake is made! ;)
How do you thread international 430 hay baler?
Twine comes out of the twine box, through the tensioner, through a couple of ceramic rings then 1 piece of twine through each needle eye. Once through the needle eye it goes back along the chamber floor and tie it off to something sturdy. The baler will thread the twine into the knotters at the first cycle. A common problem on old balers is the needle eyes have grooves warn in them. You should use a round file to file out the groove so the twine has a smooth surface to run over. A rough surface will cut the twine.
How do you time Massey Ferguson Model 12 hay baler knotters?
How do adjust the knotters on #12 Massey Fergurson hay baler
46 international hay baler is knotting twine twice and won't release from bale hook?
if your getting 2 knots... the knotter is going around two times... adjust the cam Hope this helps....
What is a hay baler tucker finger?
A hay baler tucker finger is a component of a hay baler that helps to guide and position the hay as it is fed into the baler. It works by "tucking" the hay into the pickup mechanism, ensuring an even and consistent flow of material into the baling chamber. This aids in the efficient formation of bales and helps prevent clogs. Tucker fingers are crucial for maintaining the overall performance and productivity of the baling process.
Does anyone make an ATV hay baler?
No.
When was the hay baler invented?
The inventor of the hay bailer was a man named Innes. It was invented in 1936. the hay bailer was not the large round bailer but the small square bailer
