Epoxy can ruin pictures if not applied properly as a protective coating. It can cause discoloration, bubbling, or a cloudy appearance on the surface of the picture. It is important to follow instructions carefully and test on a small area before applying it to the entire picture.
DO NOT GAP THEM. You will ruin them. Put them in right out of the boxes, or you will ruin the platinum coating and they will not fire correctly.
Probably. If you try to take it off, it might take the coating off of the CD.
no its just like drawing on them again
Yes, and the gap is .051, set at the factory. DO NOT GAP THEM OR YOU WILL RUIN THE PLATINUM COATING ON THE TIPS!
cannot see from distance I wouldn't advise it... I put it in a plastic drinking cup once... It ate threw it in seconds... Since eyeglasses are made from plastic... with a protective coating for scratches and glare... You would surely ruin them!!!
No, it won't ruin your hair, but you should only flat iron it straight when it is completely dry and you should use a heat protective spray first to protect it from damage. But it will not ruin your hair, just damage and dry it out.
DO NOT gap the plugs. They are factory set at .054. If you DO gap them, you will ruin the platinum coating and they will be NO GOOD!
Wires and plugs constitute a tune-up. DO NOT gap the plugs, it will ruin the platinum coating.
They are spark plugs. And you put them in right out of the boxes. If you stick a feeler gauge in them, you will ruin the platinum coating and they will not fire correctly.
DO NOT GAP THEM. You will ruin the platinum coating and they will not fire enough to drive your car. The gap is preset at .054" at the factory, so put them in right out of the box.
Take the old ones out, put the new ones in. Do NOT "set" them, you will ruin the platinum coating. Use the grease that comes with them.
You DO NOT gap the plugs on the Focus, you will ruin the platinum coating and they will not fire correctly. Put them in STRAIGHT OUT OF THE BOX!!