0
What else can I help you with?
How do you reset check engine light on 1991 Toyota Previa?
To reset the check engine light on a 1991 Toyota Previa, you can disconnect the negative battery terminal for about 10-15 minutes. This will clear the engine codes and reset the light. Alternatively, if you have access to an OBD-I scanner, you can use it to clear the codes directly. Make sure to address any underlying issues that caused the light to activate before resetting.
How do you reset the oil light on a Toyota tercel 1991?
go to your owners manuel, there is a section in there that will tell you or call your local dealer
How to reset check engine light 1991 Toyota land cruiser?
try disconecting the battery or pulling the ECM fuse
Where is ECU reset button for a 1991 Toyota cressida?
There is no ECU reset button.
How do you reset engine Light on 1991 Volvo 240 DL?
how do you reset engine light on 1991 volvo 240
How do you reset the brakelamp light on the dashboard - Honda prelude 1991?
reset the brakelamp light on the dashboard - Honda prelude 1991
How do you reset the check engine light on a 1991 Mercedes Benz 560 sec?
How do you reset the check engine light on a 1991 mercedes Benz 560 Sel
How do you reset the 'service ccr' light on a 1991 Eldorado?
To reset the service CCR light on a 1991 Eldorado, disconnect the battery for 10 minutes. Reconnect it and start the car.
What is the brake light number for a replacement on a 1991 Toyota pickup?
I am looking for the bulb number to replace a burnt out bulb on a 1991 Toyota pickup
How do you reset your check gauges light in a 1991 Chrysler 5th avenue?
There is no reset for a check gauges light. If the light is on, there is a problem either with the temperature oil pressure or voltage.
Why is the AC light blinking on 1991 Toyota Camry?
If an AC light is blinking on a 1991 Toyota Camry it may indicate that a belt is slipping. The AC light may also blink indicating that the system has been overcharged.
How do you reset your check engine light on a 1991 Mitsubishi?
Have vehicle scanned to determine the problem
