0
I have not worked on this particular electric motor, but I have replaced bearings on a furnace fan motor. The furnace motor had bronze sleeve type bearings. A replacement was found at a local hardware store that had a large selection of fasteners, etc in sliding trays. The standard size sleeve bearing that was available matched the ID and OD of the motor bearing, but was longer, so I had to cut it to match the length. Then carefully press out the old bearing and press in the new one, and lubricate with sae 20 machine oil periodically.
What else can I help you with?
Related Questions
Trending Questions
Who makes a 200 Thread Count Duvet Set?
What are trade names of cotton?
If there is an obvious arterial bleed in a care under fire situation what should you do to control the bleeding?
How can I get balloons to stick to a wall effectively?
How do you make chocolate crackles?
Where can you buy hectograph paper?
How do you capture oil?
How do you replace a heater switch in a Trailblazer?
How is cotton different from nylon?
Can you use nail glue to stick an earringl on your tongue?
Where can you find agates in Louisiana?
What do I do when a vinyl shutter fades?
What is pinpoint stitch?
Is elmers glue suitable for lamp shades?
What are the advantages to having attic insulation installed?
How do you get a girlfriend if you are not very attractive?
What are cricut cartridges?
What is power 99 number?
How do you install side marker bulb on 2001 aurora?
How do you get the film off your hard wood floors?
Copyright ©2025 Answers.com. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Answers.