answersLogoWhite

0

If the tank is built properly the bottom will have a low spot with a drain valve or a "pick up" tube plumbed into the low spot.

Allow the water to settle into the low spot and remove or drain the water. If you are patent and go slow it works better.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

Is there a way to remove water from kerosene tank?

There is usually a drain plug on the bottom, release this and the water will come out.


What is a gallon tank?

It is a tank that will hold one gallon of water when filled to the brim. No tank is ever filled to the brim so the tank will never actually hold a gallon of water. It is not large enough to properly house any fish.


Eva has filled a tank with water but has realized that there is a leak She knows that the amount of water left in the tank will be a function of the number of seconds since she filled it Eva names t?

True


Your wife filled the oil tank with water what do you do?

take it to the shop


What do you call a tank filled with fish and water plants?

Aquarium


A water tank has a mass of 3.64kg when empty and a mass of 51.8kg when filled to a certain level What is the mass of the water in the tank?

458


How much kerosene can you add to oil tank?

It is not recommended to add kerosene to an oil tank without consulting a professional. The amount of kerosene that can be added will depend on various factors such as the type of heating system, the current oil in the tank, and the climate. Adding kerosene incorrectly can affect the efficiency and safety of the system.


Why kerosene floats on water?

kerosene floats on water because kerosene is less denser than water


How long does it take to heat water in a hot water tank?

If you just filled the tank on a 40 gal. about 30 to 45 min.


Which liquid floats on top water or kerosene?

When water and kerosene are mixed kerosene will float on top.


How do you change the coolant in the recovery tank of a 2003 Chevrolet Impala?

I recently did an intake manifold gasket replacement. I removed the coolant tank from the fender well by removing the two screws on the top, disconnecting the hose from the radiator, and lifting the tank from the lower retaining pin. It was easier than I thought. I had oil mixed with the coolant and I cleaned the inside of the tank with a little kerosene. I then rinsed it with hot soapy water and rinsed again with clean hot water. I reinstalled the tank and filled it with new coolant.


How do you get a bag of fish out of a tank filled with water without getting in the tank?

why would you get into the tank, just reach in and take out the bag. you are a waste of skin