The adjuster is located in the engine compartment on top of the gearbox assembly. It is easier to see with the airbox removed but can also be accessed with it in place. You will see the clutch release arm and the cable attached to it. Slacken off the 10mm locknut at the end of the cable and by pulling on the end of the cable the plasitic portion of the adjuster will move away from the release arm. The plastic piece is also threaded onto the cable and by screwing in or out will adjust the freeplay between the release bearing and the cover plate. It should be adjusted so that both the clutch pedal and the brake pedal are about the same height when viewed in the car.
about 800 Kg.
To adjust the fuel mixture on a Daewoo Matiz 800, locate the fuel mixture screw on the carburetor, if equipped. Turning the screw clockwise typically enriches the mixture, while turning it counterclockwise weakens it. It's essential to make small adjustments and monitor the engine's performance, such as idle stability and acceleration. Always consult the vehicle's service manual for specific instructions and settings.
i have owned a matiz 800 cc for a few months , i get around 40 mpg in buzy town traffic and 55 - 60 on long runs i love my matiz it seems to run forever on £10 of petrol
I live in Kansas City and paid about $800 for a new clutch, installed, on my 1990 Celica GTS.
the big end bearings torque down at 55 - 65 Nm
freeview 1, cable 101, if you are in Wales and want English bbc1, 800
The labor to replace a clutch on a 1996 Pontiac Sunfire can range from $670 to $850, depending on where you go. This does not include the cost of the clutch itself, which is roughly $800.
it depends on what kind of cluch you want to go with,at a Chevy dealership you can get a Toyota clutch or a chevey clutch. I had to put in a new clutch in my 96 prism and it was a Toyota and it costed me about 800
You can buy a firewire 400 to 800 adapter cable from any good computer shop on the high street. You can also go online to eBay and Amazon to buy this item.
How to adjust the idle speed If you have a carburetor, there is a crew on the driver side behind the throttle cable it usually has a spring on it if you turn it to the right it idles up left it idles down If its a fuel injected motor idle is handled by the computer. There usually is a "base idle speed" around 800-1000 RPM. This normally doesn't need to be adjusted. Have a look for carbon build up on the butterfly as well, this will influence idle too. u can also adjust the cable there's two nuts that hold the the cable to the injection adjust one way to lower and the other way to raise Also: check & tighten all hoses as even slightly leaking hoses raise & lower ur idle speed.
The torque settings for the cylinder head bolts on a Daewoo Matiz 800 are typically around 20 Nm (15 lb-ft) for the initial pass, followed by a further tightening to 90° for the final pass. It's important to follow the specific sequence for tightening to ensure even pressure across the cylinder head. Always consult the vehicle's service manual for the most accurate and detailed specifications.
If one is interested in purchasing a firewire 800 cable it is recommended to check out popular stores that carry these type of items like Best Buy or Wal Mart. These stores typically have these in stock, but if they don't, it is recommended to purchase it off of Amazon.