length(L) of the diameter is called as the circumference........... L=∏*D.........where ∏ is 'pi' and equivalent to 22/7. and 'D' is the diameter of the circle.
You don't. You can calculate iits radius and cross-sectional area but its diameter has insufficient information to calculate its length
To calculate the arc length of a sector: calculate the circumference length, using (pi * diameter), then multiply by (sector angle / 360 degrees) so : (pi * diameter) * (sector angle / 360) = arc length
If you only know the length, and nothing else, you can't. If you know the length and the volume, you can calculate the diameter.
You cannot. Diameter and length can, for some particular shapes, give you the volume. But that will not give you the mass unless you know the density of the substance.
D=Diameter L=Length ={(D^2)/(162)*L}
Of a circle: divide the length of the circumference by the value of Pi (about 3.14159). The answer is the diameter. Half of the diameter is the radius
diameter of a circle = 2*radius or circumference/pi
To calculate the volume of a cylinder, first determine the height or length of the cylinder as well as the diameter. Divide the diameter by two to get the radius, then use this formula:Volume = radius2 x Pi x length (or height)
To calculate shaft taper, measure the diameter at two points along the length of the shaft. Subtract the smaller diameter from the larger diameter to find the taper amount. Then, divide this difference by the length of the taper section to determine the taper per unit length. This result is often expressed as a ratio or in degrees, depending on the application.
The length of a radius is not the length of a diameter. The diameter is two times the length of the radius.
You can either measure it, or calculate it if you know the diameter (radius = diameter / 2), or the circumference (radius = circumference / (2pi)).
The formula to calculate taper in millimeters would be: (small diameter - large diameter) / taper length. The result will give you the taper in millimeters per unit length.