To change the indicator relay switch on a 2001 Seat Toledo, first, disconnect the car battery to ensure safety. Remove the steering column cover by unscrewing the necessary screws, and locate the indicator relay switch, which is typically found near the steering column. Disconnect the wiring harness from the old relay, remove it, and then install the new relay switch by reversing the process. Finally, reassemble the steering column cover and reconnect the battery to test the new indicator switch.
My data is showing the indicator relay as being part of the hazard light switch.
The turn indicator relay in an Audi TT is integrated with the hazard switch. To replace the relay you would need to replace the hazard switch.
The turn signal indicator relay switch can be found below the dashboard on the drivers side. The signal indicator relay switch should be labeled as such.
its pluged in to the wiper, light,indicator switch assembly.
its pluged in to the wiper, light,indicator switch assembly.
1. Remove the plastic covers around the steering column. 2. Take the single screw out of the centre of the switch gear. 3. Pull the two wiring plugs out of the rear of the switch gear. (they hinge out) 4. Remove the indicator relay from the lower indicator side. It's a 3 pin relay.
the relay is behind the warning switch , the triangular one in the middle of the dash, from my understanding you need to pop out the part of the dash that suround the switch but i had my one changed in a service and it was cheap. watch out through the relay is massive as it had both the indication and the emergency electrical controls in it.
There is a relay switch in the circuit which switches the light on & off when you activate the turn signal.
To change the indicator relay in a Volkswagen Golf, first, locate the relay box, which is usually found in the engine compartment or under the dashboard. Remove the cover and identify the indicator relay, often labeled in the diagram on the cover. Carefully pull the old relay out and replace it with the new one, ensuring it is securely seated. Finally, test the turn signals to ensure they are functioning correctly.
try indicator relay switch,,its in the steering colum,and its square shaped
Under the actual indicator. There are 5 screws holding the steering column cover together, remove them (all underneath the column) then under the indicator you will see the relay switch (black box thingy) Why do I know? I have a fiesta mk4 and the relay has gone, resulting in no indicators at all.. not even on the dashboard.
To change the indicator relay on a Renault Espace Mark 2, first locate the relay, which is typically found in the fuse box under the dashboard. Remove the fuse box cover and identify the indicator relay, often labeled in the diagram on the cover. Carefully pull out the old relay and replace it with a new one, ensuring it is securely seated. Finally, test the indicators to confirm that the new relay is functioning correctly.