How do you change air filter on 2004 Saab 9-3?

Answer 1

Changing air filter on '06 Jetta 2.5L1. Make sure the car is off and the key is out of the ignition.

2. Make sure the engine is cold.

3. Pull the engine cover straight up - there are 4 rubber-suspended "legs" holding it. Pull the fronts first, from the corners. Pull the rears up too - wear gloves, can hurt yourself due to the force required.

4. The air filter is in the back section of the engine cover, on the underside. There are 5 screws to undo (no need to take them out, just unscrew. The air filter cover swings on rear hinges.

9. Put back in reverse order (filter, cover on engine)

Answer 2

The air filter is hidden in the right sector of the engine. Under a large flat plastic box and the intake air duct. There are metal clips securing the box, and screw to remove the metal heat shield. then replace the filter.

Answer 3

To change the air filter of an 2007 Jetta GLI, remove the two bolts securing the air intake. Trace the intake to the sensor and squeeze the clamp. Pull the air house from the sensor. Press the MAF locking button and pull the harness. Remove the air filter and slide new one in its place. Reattach the sensors and hoses.

Answer 4

Here is a step by step instruction to replace the filter on your car:

1) You will need a screwdriver. Set the wipers in the upright position. Open the hood. Dismantle the cover's right hand clips. Remove the clip on the corner tab to the windscreen corner.

2) Loosen the rear main seal halfway. Lift it off of the foam block and lift up the front edge of the cover so that the hood and the clip release on the rear edge. Fold back the corner tab. Fold up the cover half way.

3) Fold up the clips from the filter holder. Remove the cabin air filter. Lift up the drainage hose and clean it. Fit the drainage hose and insert a new cabin air filter. The new filter should be fitted with the arrows directed in toward the car.

4) Fold back the holder clips and fold down the cover. Fit the corner tab under the windshield molding. Insert the hook under the windscreen and press down the cover so that the clips lock. Fit the clip to the corner tab to the windshield corner. Lift up the foam block and fit the clip. FIt the rear main seal, then check the operation of the wipers and close the hood.

Answer 5

The filter is at the front of the engine block, accessible from above or below. After draining the oil from the sump simply unscrew the filter. If it's tight, clean it and try gripping it with rubber gloves. If it's really tight use a filter removal tool or puncture the filter and turn it with a screwdriver.

Answer 6

You need to remove the lower sound deadening/aero pieces with a T27 Torx driver. Locate the filter housing. Remove the drain cap (small end piece) from the filter housing, and use a small screwdiver to gently push the orange rubber stopper up and to the side to drain the filter. You need a 36mm socket to remove the filter housing. Once the housing is removed, simply pull the old filter element out of the housing and replace it with the new one. Also, replace the gasket around the rim of the housing and re-install. Make sure to move the orange rubber stopper back into position before filling the car with oil.

Answer 7

HOW DO i CHANGE THE OIL ON MY 2003 Golf GTI.

I HAVE MISTAKENLY PUT DESEIL OIL IN

Answer 8

The air filter is built into the engine cover. Look up how to take the engine cover off then flip it over and unscrew the air filter compartment.

Answer 9

The air filter is very easy to change. Remove the cover from the air filter housing. The air filter will lift out. Drop the new air filter in and replace the cover to its original position.