Open the hood of your Impala and remove the negative battery cable with your socket set.
Sit in your driver's seat and look at the clear plastic shield that rests in front of your odometer and other gauges. You will have to first remove this shield.
Find the two screws that hold the clear plastic shield in place. They are located at the top rim of the shield. Remove them with a Phillips screwdriver. Pull the plastic shield out and set the two screws safely inside it so you do not lose them.
Place one hand on each side of the instrument board and jiggle it slightly util one side or the other moves forward. Pull the entire panel forward slightly. However, do not pull too hard, as there are an abundance of wiring harnesses attached to the back.
Locate the small, clear light bulb. Remove it with your finger and stick the replacement bulb in its socket. Replace the instrument panel and clear plastic shield.
Replace the negative battery cable.
It requires a scanner to properly diagnosis a check engine light.
Time to change your oil in your engine!
The check engine light will illuminate.
Check engine is an error. You have to go at a garage to see what is the error code, then correct the problem.
The check engine light does not come on for an oil change.
The check engine light has nothing to due with an oil change.
How do you change a tag light on a 2002 impala
To reset the Check Engine Light you must go to the trunk of your car get a cro-bar and smash the dash board until the light doesn't come on no more...
To reset the Check Engine Light you must go to the trunk of your car get a cro-bar and smash the dash board until the light doesn't come on no more...
The check engine light has nothing to do with an oil change. The check engine light is reset with a scan tool after repairing the failure that caused it.
Who to Change engine check light bulbs on a 1996 BMW 318i?
To reset the check engine light on a 2003 Chevy Impala, you can disconnect the negative battery terminal for about 10-15 minutes. This will clear the engine control module's memory. Alternatively, you can use an OBD-II scanner to read and clear the trouble codes, which will also turn off the check engine light. Keep in mind that if the underlying issue isn't resolved, the light may come back on.