# Remove the license plate. #
# Remove the screws from the license plate lamp. # Remove the license plate lamp from the end gate. # Remove the license plate lamp socket, turning counterclockwise. # Remove the bulb from the license plate lamp socket. #
# Install the bulb to the license plate lamp socket. # Install the license plate lamp socket, turning clockwise. Notice:Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
# Install the license plate lamp to the end gate. Tighten
Tighten the screws to the license plate lamp to 2 N·m (18 lb in). # Install the screws to the license plate lamp. # Install the license plate.
how do you change the light bulb over the license plate on 2000 eclipse
how do you change the rear license plate light on a 1999 Buick Regal
It is very easy to change the license plate light on an Oldsmobile Aurora. All you need to do is remove the license plate and look above where the plate was. There are bolts that are holding the light in. Unscrew the bolts and then replace the light.
license plate light just pops out of the bumper with a screw driver.u can buy a new light at auto store or just change the light bulb
If your license plate light is out change the bulb in it, if you have taillights your fuse is good as the license plate light uses the same fuse as the taillights.
There are about 4,401,590 license plates registered in Colorado. Statistics are reported after completed years. In 2011, there were 4,224,590 light trucks and passenger vehicles registered in Colorado. There were also 173,000 motorcycles, and 4,000 buses.
Go to AutoZone, when you purchase the bulbs, they'll install for free
show please how change plate light on an 2007 nissan sentra
To change the license plate light on a 2002 Geo Tracker, remove the light lens with a small screwdriver. Take out the old bulb and replace with a new one. Tighten the screws on the light lens.
=== ===
how to change 2005 equinox license plate light i removed the screws but it didn't release
How do I change the license plate bulb on a 1993 Lexus ES 300