you have to remove the starter to replace the relay and the relay cost almost as much as the whole starter so you are better off just replacing the whole starter.
Should be on top of the starter - follow the + battery cable
The starter solenoid is attached to the starter.
Disconnect the battery cable. Remove the bolts that hold the starter in place. Disconnect the wires. Instahlation is in reverse.
the starter relay.
To change the starter relay in a 1995 Chevy S10 pickup, first, locate the relay in the fuse box under the hood. Disconnect the negative battery terminal to ensure safety, then remove the relay by pulling it straight out of its socket. Install the new relay by pushing it firmly into the socket, and reconnect the negative battery terminal. Finally, test the starter to ensure it is functioning correctly.
That other relay should be the AC compressor relay.
It is mounted on the starter motor itself. When you get another starter, it will have the solenoid mounted on it already. If it is bad, just replace the starter, I would not change just the solenoid.
In the relay/fuse center under the hood.
The starter relay feeds power to the starter when the switch is turned to start. The relay will be mounted either on the fender or on the firewall.
is it a 4x4?? yes
how to remove the starter from a 92 s-10 4x2 with a 2.8 engine
1995 to 1998 S10 fuel pump relay is located in the glove compartment behind the door marked "relays". It is the first relay on the left.