answersLogoWhite

0

To change the license plate light bulb on a Mercury Tracker, first, locate the license plate light assembly, typically found above the license plate. Use a flathead screwdriver to gently pry off the lens cover or assembly. Remove the old bulb by twisting it counterclockwise, then insert the new bulb by twisting it clockwise until secure. Finally, replace the lens cover, ensuring it snaps back into place.

User Avatar

AnswerBot

6h ago

What else can I help you with?

Related Questions

How do I change the license plate light in a 2002 Geo Tracker?

To change the license plate light on a 2002 Geo Tracker, remove the light lens with a small screwdriver. Take out the old bulb and replace with a new one. Tighten the screws on the light lens.


What circuite is the license plate light on a Mercury Mystique?

park light circuit.


How do you change the Chevy Tracker tag light on 2001?

Both the lens and the light pull out.


How do you change a rear license plate light in a 2000 Mercury Villager?

Just unscrew the two screws that hold on the small clear lens and pop the bulb out.


How do you change a license plate light bulb on a 2000 Mitsubishi eclipse?

how do you change the light bulb over the license plate on 2000 eclipse


How do you change a rear license plate light bulb on a 1999 Buick Regal?

how do you change the rear license plate light on a 1999 Buick Regal


How do you change the license plate light on Oldsmobile Aurora?

It is very easy to change the license plate light on an Oldsmobile Aurora. All you need to do is remove the license plate and look above where the plate was. There are bolts that are holding the light in. Unscrew the bolts and then replace the light.


How do you change the license plate lights on a 2000 Chevy Tracker?

You don't need to take the whole back panel off to do it!!(learned the hard way) the light cover on the bulb twists out, and it might take some elbow grease to twist it, then the bulb is easy to change.


Change transmission light in a Mercury Tracer 1999?

There is no change transmission lamp.


The license plate and right side brake light bulbs for a 1999 Mercury Sable do not work is that a bad fuse?

The 1999 Mercury Sable license plate light and the right side brake light are on the same fuse. If the fuse was bad neither brake light would work. The problem probably is burnt out lightbulbs.


How do you change license plate light on 1987 Ford F-150?

license plate light just pops out of the bumper with a screw driver.u can buy a new light at auto store or just change the light bulb


How do you change the license plate light on 2002 Mercury Villager?

The license plate lights are located just above the license plate. Open the tail gate part way to make removal easier (unless you enjoy squatting). Remove the Phillips screws and replace the affected bulb.