I have a Mits Galant 1990 A/T and recently repaired a leaking washer pump. The washer pump in my Galant is attached to the lower part of the water reservoir. You need to remove the electrical connection to the pump and remove the reservoir. Afterwards, you can remove the washer pump and replace it with a new one. To ensure you have no leaks when you install the new pump, I suggest you line the holw of the reservoir (the hole where the pump goes into reservoir) with silicone paste or any other sealant. Replace the reservoir and the connect the electrical connection.
200-250$
Begin by removing the hose from your windshield washer pump. Remove the windshield washer pump wiring harness. Remove the windshield washer pump retaining bolts. Reverse the process to install your new windshield washer pump.
How do you change the windshield washer pump on a 2003 Pontiac Grand Am
how to change fuel pump on mitsibishi galant 2005 2.4 liter
how to replace windsheild washer pump 2003 buick regal
To change the washer pump on a Renault Megane MK2, first, disconnect the vehicle's battery for safety. Then, remove the windshield washer reservoir by detaching any fasteners and disconnecting the hoses. Once the reservoir is out, locate the washer pump, disconnect the electrical connector and hoses, and remove the pump from the reservoir. Replace it with the new pump, reassemble everything, and reconnect the battery to test the new washer pump.
some models th pump is inside the winshield bottle, others mounted about 6 inches behind bbottle container.
Remove wheel and wheel arch cover Washer pump is under the tank
Very carefully.
it is located on the bottom of the washer fluid bottle. you change it by unplugging the electrical connecter, removing the washer hose from the pump, and the gently prying the pump out of the bottle.
To change the washer pump on a Kangoo van, first, disconnect the battery for safety. Remove the windshield washer reservoir by unscrewing any bolts and disconnecting the hoses. Take out the old washer pump, usually attached to the reservoir, and replace it with the new one. Reassemble the reservoir, reconnect the hoses, and test the pump to ensure it’s functioning properly.
I have the same problem except I can't even find it, do you know how to access or location of the washer pump?