To remove anti-freeze stains from driveway pavers, soak the area with water. Sprinkle powdered laundry detergent over the stain. Place a few layers of newspapers over the detergent and press down flat. Wet the paper thoroughly, and allow to sit for a few hours. After a few hours, discard the newspaper, and scrub the stained area with a wet, nylon bristled brush. Keep the brush well-rinsed in clean water as you remove the sudsy residue and anti-freeze. Blot the area dry with crumpled newspapers.
Stain on asphalt can be removed with a good grease removing household cleaner. For concrete, the stain may have to be removed with muriatic acid.
Not really bad for the driveway, but bad for any animals or children that would get into it. Just hit the stain area with dish detergent and hose it off with alot of water to dilute it as much as possible.
To effectively clean oil off your concrete driveway, you can try using a degreaser or a mixture of baking soda and dish soap. Apply the cleaning solution to the oil stain, scrub with a brush, and then rinse with water. Repeat the process if necessary until the oil stain is removed.
pool acid on brick pavers works well to remove almost anything. Depending on the extent of the stain, the acid can be mixed with water, applied, scrubbed with a wire brush and rinsed with a hose pipe
Elbow grease
To remove a stain from pavers effectively, start by scrubbing the stained area with a mixture of water and dish soap. If the stain persists, try using a solution of water and vinegar or a commercial paver cleaner. Scrub the area with a brush or pressure washer, then rinse thoroughly with water. Repeat the process if necessary until the stain is removed.
Yes, WD-40 can stain brick pavers due to its oily composition. If spilled, it may leave a residue that can be difficult to remove, especially if not cleaned promptly. To prevent staining, it's best to use WD-40 carefully and avoid direct contact with the pavers. If a stain does occur, using a degreaser or a mixture of soap and water may help in removing it.
To effectively remove an oil stain from your concrete driveway, you can try using a commercial degreaser or a mixture of baking soda and dish soap. Apply the solution to the stain, scrub with a brush, and then rinse with water. Repeat the process if necessary until the stain is removed.
The most effective method for removing stains from pavers using a paver stain remover is to follow the manufacturer's instructions carefully. Typically, you would apply the stain remover to the affected area, let it sit for the recommended amount of time, and then scrub the stain with a brush or pressure washer. Repeat the process if necessary until the stain is fully removed.
You can remove the stain from the gravel the same way you clean the driveway, with muratic acid sprayed from a pump sprayer. Im not sure of your budget constraints on this, because the dimensions of the playground is not given.
to get an egg stain off of a concrete driveway, go to your local pool supply and get a bottle of muratic acid.be careful not to get any on yourself, children or pets. pour the acid on the stain and let set,if you desire, you could use a stiff broom to get the stain off. as for the door, it will need to be sanded and re-painted, if you have thew same paint on the door, you can just redo the area where the stain is at
Stain, what stain The Power of Oxi Clean if it aint clean, it aint Oxy-Clean