0
What else can I help you with?
How do I drill a half inch hole in sandstone?
by using a drill
What is the recommended drill bit size for a 15/64 hole?
The recommended drill bit size for a 15/64 inch hole is a 15/64 inch drill bit.
What is the recommended size of the drill bit to use for a 7/16 hole?
The recommended size of the drill bit for a 7/16 inch hole is a 7/16 inch drill bit.
What size pilot hole drill bit should be used for installing a 1/4 inch screw into hardwood?
A 3/16 inch pilot hole drill bit should be used for installing a 1/4 inch screw into hardwood.
What size drill bit for a one quarter inch bolt?
For a clearance hole you need a 9/64 drill bit.
What is the diameter of the tap drill for a 1 inch 8 UNC threaded hole?
7/8 diameter drill or .875
What size drill do you use for a five sixteenth inch dia lag screw?
It depends on the material you are fitting it into. In most wood I pre-drill a 1/4 hole for this. In softer woods i would drill a smaller hole .
How do you drill a five sixteenth inch hole four inch depth flat bottom hole?
5/16 hole X 4 inch on a flat bottom hole: This will depend on the material, and tools available. Use a 1/8 bit, then 5/16. If you are not sure how deep the drill bit is in the hole, paint white out on the bit as your 4 inch mark so you can see it while the drill is spinning. If the material is metal, you will need coolant. To get the flat bottom: it wood, put a flat ended bolt into the hole and hammer, it will flatten the hole, it metal, forget about it, the hole is quite flat, and a pain in the butt to change. :-)
Is it possible to drill a three inch hole through three 2x10's?
i would use a long shafted hole saw
What size drill bit for 56 inch hole?
One that's too big for you to hold.
The weight of a solid 6 inch concrete block?
30 kilos
How do you drill into oak window frames to hang rods for drapery?
You will have to drill a pilot hole before screwing into oak. Use a cordless drill and a 1/16" inch bit or 3/32.
