Firstly you find out how the DE got into the pool - must be a broken filter pad. Fix that, then vacuum the pool. No point vacuuming before you fix the filter problem, or the DE will finsih up back in the pool.
Yes, too much diatomaceous earth (DE) powder in a pool can be dangerous. Excessive DE can lead to poor water circulation, cloudy water, and can irritate skin and eyes. Additionally, if ingested, it may cause health issues for swimmers. It's important to follow manufacturer guidelines for proper DE usage in pool filtration systems.
For a 17,000-gallon pool, you typically use about 1 pound of diatomaceous earth (DE) powder for every 5,000 gallons of water. Therefore, you would need approximately 3.4 pounds of DE to effectively filter the water in your pool. It’s important to follow the manufacturer's instructions on the DE filter for the best results. Always ensure the DE is evenly distributed to maintain proper filtration.
Yes, you can add powder chlorine to a Pebble Tec pool. However, it's important to dissolve the powder in water first before adding it to the pool to prevent any potential damage to the surface. Always follow the manufacturer's instructions for dosage and application. Additionally, be sure to test and balance your pool water afterward to maintain optimal water chemistry.
You add diatomaceous earth (de) powder to a pool based on the size of the filter. Most pool filters have a plate on the side telling you how much de powder you need to add. If your filter does not have such a plate, the general formula is that you add 1 lb. of de powder for every 10 sq. ft. of filter area. That is, you need to measure the length, width, of your filter, taking the pleats into account, and use the formula "sq. ft. = length x width" to determine the square footage of your filter.
SHOCK!! Its a powder you can buy at a pool store or chemical store.. its chlorine in powder form, you just dump it in your pool stir it up a bit, wait a day or two, and the pool should be clean.
It's best to pour the bag of shock into an empty gallon jug, say from algecide or water and then fill it with water till it dissolves then pour in thru skimmer. If the powder just sits on the pool liner bottom, it will eat at the vinyl.
it is a mixture because H2O is a compound and chlorine is an element, element + compound = mixture, so if pool water is H2O + Cl, then it is a mixture
To convert powder pool shock into liquid shock, dissolve the recommended amount of powder in water according to the manufacturer's instructions. Typically, you would add the powder to a bucket of water, stirring thoroughly until it is completely dissolved. Once fully mixed, you can then pour the liquid solution into the pool, ensuring even distribution. Always wear protective gear and follow safety guidelines while handling chemicals.
I would read the ingredient list on the package and find out if there are poisons in the powder and if so I would drain the pool and clean all the surfaces and then refill. If there are no poisons in the powder then putting a soft cloth over the skimmer (make sure water still passes through) will collect the particles, cleaning all the surfaces in the pool with some clothes will help to reduce the particles. Here is my blog how I handle my pool. http://live-efficient-green.blogspot.com/2009/07/pool-with-no-harmfull-chemicals.html
Check the grid and manifolds for holes or cracks.
Yes. It is important because grids inside will not get clogged by dirt, dust and other elements getting into pool and will not brake that easily. Also pool water will look better and you will have easier filter cleaning next time. Add some D.E. after backwash, too.
Drain it to your sewer if possible DE as a powder is hazardous to health so don't water the garden with it.