Almost anything you do WILL take off the top layer of paint and possibly drywall paper so be prepared to recover it with mud and sand it down.
There is no drywall glue. -If you are referring to mud (drywall compound), you scrape the lumps off at the end of each day and then wash your clothes. It always comes off.
The best type of glue for drywall installation is drywall adhesive, also known as drywall compound or joint compound.
If it is glued to the wall and the wall is drywall/sheetrock, then the paper of the drywall will come off with the mirror. Drywall/sheetrock repair will be necessary. Your best bet is to use a glaziers set of suctions cups. Buy pulling with enough pressure, the mirror will eventually break loose. It WILL damage the drywall, so either replace the mirror or the drywall. It is the mastic you are trying to break. Just before it comes loose, you will know it.
Use a dab of cooking oil and rub the glue off then clean the mirror with window cleaner to remove oil. No harm to the mirror, works on any type of glass.
To effectively remove glue from drywall, you can try using a putty knife to gently scrape off the glue. You can also use a mixture of warm water and mild soap to soften the glue and then scrub it off with a sponge or cloth. Another option is to use a commercial adhesive remover following the manufacturer's instructions. Be sure to test any method in a small, inconspicuous area first to ensure it does not damage the drywall.
To replace the side mirror of a '96 Honda Civic you will need to remove the two screws on the left and right side. Use a blade to scrape off the remaining glue. After purchasing a new mirror scrape off all remaining glue before applying the glue for the new mirror. Reattach and put the screws back in.
Pull it off! Seriously.... Its on with glue.
Razor blade scraper. That's if it is on the glass side.
Cut it off with a chainsaw then when finished, glue back on with one piece of gum. What? It's true! (If you want a broken mirror.) Improvement- u can use 2 pieces of gum or alternatively glue
Epoxy will do this .
Yes, there is a glue that can be used to re-glue a side car mirror. It is not an actual glue but more of an adhesive. That adhesive is construction silicone adhesive that is free of latex.
To effectively use mirror glue to attach a mirror to wood, follow these steps: Clean the wood surface and the back of the mirror to remove any dirt or debris. Apply a thin, even layer of mirror glue to the back of the mirror. Press the mirror firmly onto the wood surface and hold it in place for the recommended drying time. Allow the glue to fully cure before moving or hanging the mirror. Follow the manufacturer's instructions for best results.