I removed the back of a rectangular Ecclissi watch with a very small screw driver by prying from one of the watch band sides and using the watch band pin as a fulcrum. Inside it said made in China.
I have found that Home Depot carries an efficient high speed grinder that will take the back off of any watch in mere seconds! It is also very good at removing those annoying fingerprints the police keep asking you for, so be careful. Good Luck....Sincerely, Stubby
Anthony Ecclissi is 6'.
Anthony Ecclissi was born on January 14, 1989, in Montreal, Canada.
In order to take a back off of a Kahuna watch, you must use a small Phillip's screwdriver and remove the tiny screws keeping the back in place. Once you have accomplished that, the back should easily slide off.
mine is a spin off back had to use needle nose pliers and spin the back on and off using the tips of pliers and the notches in the back
If you cannot get the back of your watch back on, to prevent any destruction or further damage, you should take the watch to a professional. anonymous@oola.com
If the watch has a snap on the back, one can simply use a sharp knife to twist off the back. If the watch has a screw back, a special wrench must be used.
To remove the back of a Rolex watch, you need a case back removal tool. Place the watch face down on a soft cloth to protect it, then use the tool to carefully unscrew the back by turning it counterclockwise. Be cautious as you do this to avoid damaging the watch.
Theoretically you can twist off the back using a watch case opener, but the one I am working on right now seems so old and corroded, it won't twist off. You do have to take out the strap pins and remove the band from the watch to twist off the back.
its on the back off a kelloggs box
the back of the watch case comes off but stem recesses into watch works preventing removal of watch works unless stem can be removed
There should be four very small screws. You may have to go to a hardware store to get the appropiate screwdriver, but once you take them off you only need to pop the backing off and you're done.