Roper washers are direct drive models that use a coupler between the transmission and motor. See Sources and Related Links, further down this page, to view a home movie that shows you how to do it.
The drum is not moving
Overloading your Kenmore front load washing machine can cause increased wear on the Belt drive. Over time, the belt may wear out and break.
Not all.
No, washing machines do not typically have a pulley inside. The motor in a washing machine is connected to the drum directly or through a belt, but there is no pulley involved in the washing process.
In a top loading machine, remove the front panel. It's easier if the machine is tilted back a little. Under the bottom of the machine, there are two belts, the pump belt and the drive belt. The drive belt is the belt located underneath the pump belt. In a front loading machine, the back panel of the machine must be removed. The belt is located right behind the drum.
Oh, dude, adjusting the belt tension on a washing machine is like trying to tame a wild beast. You gotta loosen the bolt, move the motor, and tighten it back up. It's all about finding that sweet spot where the belt is snug but not too tight. Just don't let the washing machine boss you around, you're in charge here.
26"
This is a great video on how to take apart the washing machine. In reverse order, he shows you parts of a washing machine. Check out the instructions here: http://www.mindbites.com/lesson/425-fix-washing-machine
The wig-wag or spin actuator or belt is faulty. -Simple problem for someone experienced in washing machines.
There could be several reasons why a washing machine is not washing, such as a clogged filter, malfunctioning water inlet valve, broken drive belt, or an issue with the motor. It's best to check these components or consult a professional to identify and fix the problem.
an electric motor is used in a washing machineIt's a typical electric motor usually with a belt off of it to rotate the drum.
106085x