belt diagram
To perform a Maytag dryer belt replacement, first unplug the dryer and remove the front panel. Release the tension on the old belt and remove it from the drum and motor pulley. Install the new belt around the drum and motor pulley, ensuring it is aligned correctly. Reassemble the dryer and test it to ensure the belt is working properly.
The belt on a Maytag dryer is located around the drum, underneath the dryer’s top panel and around the motor pulley. To access it, you typically need to remove the front panel or the back panel of the dryer, depending on the model. The belt is responsible for turning the drum when the dryer is in operation. If the dryer is not spinning, checking the condition of the belt is a common troubleshooting step.
You don't have your tongue in the right position. Put the belt on the drum and motor and pull the tensioner pully over to install it there.
The main drum bearing is gone-resulting in the drum drooping. If this is the case, the machine should likely make a heck of a racket when cycling.
drum capacity for matytag washer model # LAT9416AAE
Common issues with a dryer drum include a loose or broken belt, a worn drum roller or bearing, or a misaligned drum. These issues can be resolved by replacing the belt, drum roller or bearing, or adjusting the drum alignment. Regular maintenance and cleaning can help prevent these issues.
That code trips when the controller wants to spin the drum but the tachometer says it isnt moving, could be a bad wire connection, a piece of clothing stuck in the drum, or worst case scenario a burned out drum bearing.
The capacity of a Maytag Atlantis MAV7600AWW is 3.2 DOE. It also offers many options such as pre wash, extra rinse and wash temp selection.
I calculate it to be 8.0 cu ft. 26.5 inch diameter drum that is 25 inches deep.
The key features of the Maytag Legacy Series dryer include advanced moisture sensing technology, multiple drying cycles, steam refresh option, and a durable stainless steel drum.
The drum is not moving
You're gonna need a flat head screwdriver, flashlight and a can of Raid. Get access to the back of the Maytag "HYE2460AYW" Dryer. Just under the control panel you will two hinges, one on left, one on the right. Remove these screws. You will now be able to open the top of the dryer, as if it were talking to you. Have someone help you hold open the top or prop it open wisely! You are now inside. On the inside you will need to remove two screws located on both left and right upper front corners. Note the white wire on the right side. These screws are holding the front of your dryer (door included) to the other three sides. Once both screws are removed cautiously set aside the front keeping mind of the white wire. You now have complete access to the guts of your dryer. To replace the belt, you need to wrap the belt around the dryer drum and the motor found under the drum. Screw screws into their proper holes. Done.