Build simple electroscope - discharge time can show humidity and ionisation situation
The Wilson Chamber has the radiation independent of the particle. This is a particle detector used for detecting ionizing radiation.
There are so many contributing factors to the price of a radiation detector. For a extremely sensitive, high end radiation detector, someone could expect to pay approx $3500 USD.
Alpha radiation is typically detected using a particle detector such as a Geiger-Muller tube or a semiconductor detector. These detectors are sensitive to the ionization produced by the heavy and charged alpha particles as they pass through the detector material. The detector then converts this ionization into electrical signals that can be measured and analyzed.
It does if you want to detect the beta radiation. Beta radiation, beta particles, can be stopped with a sheet of aluminum foil. An aluminum "absorber" would act as a shield to the Geiger-Müller (GM) detector and stop the beta radiation, which is really high energy electrons or possibly positrons. Placing a shield between the source of the beta radiation and the GM detector would block the radiation, thus shielding the detector from it. The detector would be "blind" to the radiation. Note that this would be effective if all you wanted to do was look at gamma rays. The gamma rays and the beta radiation would leave the source and head to the GM detector, the beta particles would be blocked by the aluminum, and only the gamma rays would make it to the GM tube to be counted. Links can be found below.
The detector refers to the component that actually does the detecting. The monitor is the detector plus all the other stuff that comes with it that lets people monitor the levels of radiation.
Radiation detectors can sense changes in temperature caused by a fire. When objects burn, they emit heat that can be picked up by sensors in the radiation detector. This increase in temperature triggers the alarm on the detector, alerting users to the presence of a fire.
It is used in smoke detectors as it cannot travel far in air. Alpha radiation is emitted and as long as the detector in the device is receiving the alpha radiation, then no smoke is present. When smoke particles are present, they interrupt the radiation, and so the detector doesn't pick up the radiation, causing the alarm to go off.
Detector rails generate redstone energy (for a redstone wire or other contraption) when a minecart is on them. You can make a simple minecart accelerator by placing rails like so: [minecart rail][detector rail][powered rail][powered rail][detector rail][minecart rail]
A silicon surface barrier detector is a type of radiation detector that uses a thin layer of silicon to detect ionizing radiation. When radiation interacts with the silicon, it creates electron-hole pairs which produce an electrical signal. These detectors are commonly used in nuclear physics, medicine, and other fields for their high sensitivity and fast response time.
No, the radioactive sources in smoke detectors emit alpha particles. These are very weakly penetrating and are stopped by a few centimetres of air, therefore the plastic casing of the detector is sufficient to stop any radiation.
No, a Geiger counter does not emit radiation. It detects ionizing radiation such as alpha, beta, and gamma particles by measuring the electric charge produced when radiation interacts with the detector.
i just asked for a frequency detector jst as brain wave detector.