0
You can either flip it upside down or take the back off, depending on the model. OR
Unplug the machine (preferably after you drain it)
On most 80's - 00's washing machines there are two clips under the control panel. You need to take off the end caps of the control panel (top of the machine where the dials are) if there are any, and then you will see two screws in the lower corners. Remove these screws and flip the control panel up and hold it there. Be careful as the hinges are delicate (i.e. cheap). Using a flat tip screwdriver, insert the tip into the hole you will see both on the right and left and it should catch on the little vee of the roller coaster looking clip. Rock the driver rearward (tip moving forward) and the clips should come right out. Pay attention to how they are situated before you remove them. When you are putting the machine back together, they just push back into the hole. Then make sure any hoses that need be disconnected are. Usually on the left side is sliding pieces of plastic and under there are the soap dispenser type hoses. Unclip them - remembering which goes where and tilt the entire machine cover away from the washer.
While it's all and good to try and help someone with your knowledge of appliances, it is also wise not to give advice to a layperson who it seems to have no or little experience with major appliances and could be getting himself in way over his head. As a person who has had many years experience I would tell the person asking for advice if he is prepared to buy a new appliance, since a factory trained technician would never get involved in this; because a lot of machines have a variety of spacers between transmissions and clutches . I'd fit the machine if it is lying halfway across the basement floor my stock question was "did the burglar vandalize anything else in your home after he did this to you washer". If a technician involves him or herself in the repair of such a common enough setting he could spend a long period of time going on
call-backs.
Washers up until the last few years are fairly easy to service. The Top will flip up . Use a Wonder Bar and pry up the front corners until it unsnaps. Use a cloth or rag under the Wonder Bar so it doesn't damage the porcelain surface. Once you have done that, you can see the water mixing valve and the drum safety switch. If you need to get at the motor and transmission, take the back off. You may have to tip the washer forward to check the transmission, belt and motor. Make sure that the washer is UNPLUGGED at all times and the water supply is turned off.
What else can I help you with?
How is a washing machine a open loop system?
a washing machine consider as an open loop system when all the disturbances being ignored e.g when the operator try to start the washing machine it goes start even though it don't have water inside the washing machine.
How do you get the money from a washing machine?
If you are authorized to remove the money from a washing machine, you should have been given a key to open the money compartment.
which simple machine must be used to keep a door open?
washing machine
What is the purpose of a washing machine shutoff valve and how does it function in relation to the washing machine?
The purpose of a washing machine shutoff valve is to control the flow of water to the washing machine. It functions by allowing water to flow into the machine when it is open and stopping the flow when it is closed. This helps prevent leaks and water damage when the machine is not in use.
What is the problem with a washing machine when it doesn't stop spinning?
Open the door to the washing machine. Some appliances stop when it is opened.See if you can turn the dial onto off.If all fails, call the number on the appliance.If it has no number to call, call the store you got it from.
What is the purpose of a washing machine shut off valve and how does it function in relation to the operation of a washing machine?
The purpose of a washing machine shut off valve is to control the flow of water to the washing machine. It functions by allowing water to flow into the machine when it is open and stopping the flow when it is closed. This helps prevent leaks and water damage when the machine is not in use.
How do you open the washing machine in silent hill origins?
In Silent Hill: Origins, you can open the washing machine by finding the correct item to interact with it. Typically, you need to locate a specific key or tool within the environment that allows you to unlock or force open the machine. Pay attention to your surroundings for clues or items that may help you progress. Once you have the necessary item, approach the washing machine and use it to open the door.
What type of simple machine is pulley?
drapery rod, shoelaces, washing machine, rope to open/close blinds
How can I prevent the issue of sitting water in my washing machine?
To prevent sitting water in your washing machine, make sure to regularly clean the machine's filter and drain pump, avoid overloading the machine with clothes, use the appropriate amount of detergent, and leave the door open after each use to allow for proper ventilation and drying.
How can I prevent water from sitting in the washing machine for too long?
To prevent water from sitting in the washing machine for too long, make sure to promptly remove the clothes after the wash cycle is complete. Additionally, leave the washing machine door open after each use to allow for proper ventilation and drying. This will help prevent mold and mildew growth.
How can I prevent musty odors in my laundry by ensuring there is no water left in the washing machine after each cycle?
To prevent musty odors in your laundry, make sure to remove all water from the washing machine after each cycle. This can be done by leaving the door open or using a towel to dry the inside of the machine.
Is a washing machine set on a twelve minute wash cycle an open or closed loop system?
typically open
