answersLogoWhite

0

If you have a gas oven just turn on a couple of the burners until the flames regulate and seem to be burning without any air bursts coming through

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Can helium be used to purge gas pipes before welding?

Type your answer here... no


Why do you need to purge a gas line?

Simple, to remove the air so the gas will reach the appliance


How do you purge water pipes for the winter?

The best way to purge water from pipes for the winter is to open the tap for about 24 hours. It is also a good idea to install frost proof hydrants on all outside outlets.


How do you purge a home water heater?

If you have a water heater, particularly a gas one, you will need to purge your system if air gets in. This can happen when the water main is shut off, etc. A purge usually involves draining the water with a garden hose and then restarting the heater.The air bubble interferes with the heaters ability to interact properly with the heating coil.


Where is a purge solenoid on a Chevrolet venture?

Purge solenoid is on the gas tank along with the evap cannister.


Are lead gas pipes dangerous?

Yes, lead gas pipes can be dangerous because they can release lead particles into the air, which can be harmful if inhaled. Lead exposure can cause a range of health issues, especially in children and pregnant women. It is advisable to replace lead gas pipes with safer alternatives to minimize health risks.


What gas is often used to purge or sweep vessels and often serves as a backup for compressor air?

Nitrogen gas is often used to purge or sweep vessels due to its inert properties, which help prevent combustion and contamination. It is also commonly employed as a backup for compressor air in various industrial applications, ensuring a reliable supply of gas for processes that require an inert atmosphere or pressure support.


Can nitrogen be used to purge gas pipes before welding?

Yes, and No, Nitrogen can be used to purge gas lines prior to welding, but the correct answer depends on several things, mainly, your welding application. A significant amount of resistance welding applications use N2 as a suitable environment for welding. Other applications use N2 as a purge gas, and then purge the N2 with the process gas. That said, if you were going to be using a different inert gas (Argon, Helium, Xenon, etc.) to provide the actual the actual shield for the weld, then you would still need to displace (purge) the N2 from the lines. The last statement leads to the question of; if you are going to have to purge the lines anyway, why do it twice? The answer to this question is pretty basic. Nitrogen is cheap. If you had to purge a lot of lines, or a large volume of space, you would rather use N2 to drive out the Oxygen and lower the dew point (moisture). Using one of the other welding gases would cost about ten times as much to perform the operation.


If your 1990 Geo Storm will not start after almost running out of gas how do you purge trash or air from the fuel line or fuel filter?

Replace the fuel filter.


Where is the Purge valve location on 2007 impala?

The purge solenoid that vents the air from the gas tank as it fills is immediately behind the rear wheel well on the left (drivers) side. Be sure to check if you have no voltage on the solenoid when the car is shut off.


How do you get air out of a heating pipe?

Bleed it /Purge


Use a sentence with the word purge in it?

The superheated gas could instantly purge the room of all biological contaminants.