The same way you read ANY syringe. From www.wikipedia.com (http://en.wikipedia.org/wiki/Syringes), if you click on the image of the 10ml syringe, you'll see the markings on the barrel. You measure the units of fluid from the needle side back to the plunger - so as you pull back the plunger you draw in "x" ml's of fluid as marked from the needle back. Standard safety procedures surrounding the use of a syringe should always be followed, and in no way is this short answer a full and complete explanation of how to correctly/safely use a syringe.
How full should a 1ml oral syringe be to have 2.5mg in it??
he pushes the plunger so that he removes the air molecules from the syringe and make it vacuum and then puts it in the medicine and pulls the plunger so that the liquid rises without the air molecules getting in the syringe (arjun)
To read a tuberculin syringe you simply have to look at the calibrations on the syringe. Make sure that your eye is level to avoid taking a wrong reading as a result of parallax.
The needle of the syringe is put into a container that has medicine in it. The handle of the syringe is pulled back, drawing the medicine into the tube. The needle is then jabbed into the body and the handle is pushed forward, sending the medicine from the tube, through the needle, into the body.
Air pressure helps in pulling medicine from a syringe by creating a difference in pressure between the inside of the syringe and the atmosphere outside. When the plunger is pulled back, it increases the volume inside the syringe, reducing the pressure. This lower pressure allows the higher atmospheric pressure to push the liquid medicine into the syringe, facilitating the withdrawal of the medication. Essentially, the pressure gradient created by the plunger movement enables the liquid to flow into the syringe easily.
if you need a flu injection the docter uses a SYRINGE to give you them medicine in your arm
25 gauge is the size of the needle not the syringe. they are measured in cc's
A syringe (forces medicine into the body) and a heart (forces blood round the body), so both are pumps.
It is used to hold a gas syringe in place when carrying out an experiment. The gas syringe will fill up with gas and you can read the amount of gas within it using the measuring lines. Hope it helped. Ask for any other queries that need answering.
A 6 cc syringe typically has a series of marks to indicate different amounts. Each cc is marked with a line and a number to indicate the amount. Halfway in between will be a relatively large line that may be marked, indicating half a cc. In between the half mark and the whole mark are other lines, usually indicating a quarter cc, but sometimes it is done in tenths instead. Read the number from the tip of the syringe, where the needle goes, up to the other end to see how much is in the syringe.
To measure 0.3ml in a 1.875ml syringe, you would fill the syringe up to the 0.3ml mark. This is typically the third smallest mark on the syringe. Make sure to read the measurements carefully to ensure accurate dosing.
To effectively get your infant to swallow medicine, you can try using a medicine dropper or syringe to slowly and gently administer the medicine into the side of their mouth. Make sure to aim for the inner cheek to prevent choking. You can also try mixing the medicine with a small amount of milk or formula to mask the taste. It may help to soothe your infant by offering a pacifier or breastfeeding immediately after giving the medicine.