0
Determine where the wire going to the lamp exits your house. Make sure the power is off and then cut the cable leaving enough wire to be contained in a junction box. Put wire nuts on the white and black wire and install a blank cover plate over the box. If the lamp is controlled by a separate switch, just remove the switch, cap the wires and install a blank cover on the box. (combo covers can be bought if the switch is in a multiple device enclosure.) Now dig up the post and toss it.
What else can I help you with?
How do you remove an old outdoor front lawn lamp with underground wiring?
first ,be sure power to lamp is shut off!!!!!!! remove screws from the base of the globe or actual lamp itself. running from underground and up through actual lamp post you will discover wiring connected to base of lamp ,wiring connects just beneath light bulb socket. be safe.
How do you remove a super beetle dashboard?
Open the front hood/trunk, remove the wiring cover. If you look closely there are nutsholding the dashboard on.
Where is Lexus 1998 ls 400 outdoor temp sensor how to replace?
The outdoor temperature sensor on a 1998 Lexus LS 400 is typically located in the front bumper area, often near the grille or under the front fascia. To replace it, you'll need to remove any necessary panels or the bumper cover to access the sensor. Disconnect the old sensor's wiring harness and remove it from its mounting bracket, then install the new sensor and reconnect the wiring before reassembling any removed components. Always consult the vehicle's service manual for specific instructions and safety precautions.
How do you remove front speakers for Chevy Equinox?
The Chevrolet equinox front speakers are held in place with two retaining screws. Remove the retaining screws and the wiring harness. The speakers will come out.
How do you remove front speakers in a Mitsuibishi Mirage?
Remove the speaker covers, by loosening the retaining screws. Remove the speaker retaining screws. Remove the wiring harness. The speakers will come out.
How do you remove gas tank from 69 dodge charger?
remove the wiring going to the front of the tank, and then remove the bolts from the 2 straps holding the tank up and it's out.
How do you remove front drivers side Bose speaker on a 1990 corvette?
The 1990 Chevy Corvette front drivers side speaker cover will need to be removed. Remove the speaker retaining screws. Remove the wiring harness from the back of the speaker.
How do you remove a CD changer from the boot of a Audi s3?
Remove the retaining cover from the front of the CD changer. Remove the CD changer retaining screws. Remove the wiring harness from the back of the CD changer.
How do you remove the front seats in a 2007 impala I see bolts on the rear of the tracks but not on the front of them?
Move seat fully forward, remove side trim, remove seat belt retaining bolt, remove seat tracks rear bolts, flip seat upwards, disconnect wiring, remove seat.....
How do you remove the front passenger door inside panel on a 2000 Escalade?
Using a screwdriver, remove the screws from the panel, remove the clips from the panel, and pull the panel away gently. Remove any wiring connectors, and remove the panel from the frame.
How do you replace the front wiper motor on a 95 Chevrolet Lumina Van?
Remove the wiring harness from the back of your 1995 Chevy Lumina front wiper motor. Remove the traveling arm linkage from the wiper motor. Remove the wiper motor retaining bolts. Reverse the process to install the new front wiper motor.
Change the front speakers in a ford KA?
You will need to remove the front speaker covers. The speaker covers are held in place with two retaining screws. Remove the speaker retaining screws. Remove the wiring harness from the back of the speakers. Reverse the process to install your new speakers.
