To remove the carbs on a Suzuki Madura, start by ensuring the motorcycle is turned off and cooled down. Disconnect the battery, then remove the air cleaner assembly to access the carburetors. Detach the fuel lines and the throttle cables, followed by unscrewing the carburetor mounting bolts. Carefully pull the carburetors away from the intake manifold, taking care not to damage any gaskets or seals.
the only way to put fuel injection on a bike with carbs is can the ignitopn and carbs and have some whiz kid map you a new igniton system and have a fuel injector system that might work with a madura
loosen clamp on airbox ..disconnect throttle and choke cables & hoses and fuel lines...take out the 2 10mm bolts holding each boot to the engine(4)boots.. seperate boots from carbs on right side and remove the Mikuni aluminum plate lft side and pull the carbs out the left side..
The air filter is located below the seat on the madura GV1200 1985 along with the battery and the fuse boxes. RVJ
Use your key on the left side by the seat. turn it counterclockwise. and the front seat should pull off. Once you remove the front seat there are two releases to remove the rear seat.
Bank of Madura was created in 1943.
Madura College was created in 1889.
in between the carbs
you have to take the air filter box out then the throttle bodies will slide back off the carbs and then you can pop the carbs off.
Madura College's motto is 'Learning Shines with Righteousness'.
how to remove the hood of soft top grand vitara suzuki
DT6 has one carb, DT8 has two carbs. Same carbs, but different jetting. Fit is the same, but the jets are different.
1. Remove fuel tank. 2. Disconnect throttle cables 3. Remove side covers 4. Remove air-filter case under seat 5. At top of air-box (between filter box and carbs) there are 2 bolts with 10mm hex heads, remove these. 6. Remove crankcase vent hose from the air-box 7. Loosen clamps for rubber boots from air-box to carbs as well as the clamps on rubber manifolds to engine 8. Slide air-box away from carbs 9. With a rocking motion, pull carbs rearwards from engine. The carbs will come out from manifolds 10. Rock carbs with engine end pointing up, gently but firmly work the carbs out to the right side of the bike.