Remove the drivers side door panel of your Mercedes-Benz. Remove the door lock assembly retaining bolts. Remove the door lock linkage. The door lock assembly will come off.
The battery is located in the left side of the trunk. just remove the left tail light assy and the floor.
Messy job, On the driver side you need to remove air intake assy and throttle assy to be able to remove the valve cover. On the passenger side, you have to remove the air intake plenum to get to the valve cover. Time consuming... but not impossible.
remove the side marker light assy Phillips screws, the assy will slide out. you then have access to the three 10mm bolts holding the fog light assy in. remove then and push out the fog light assy. then remove the four Phillips screws from the corners of the fog light to separate the assy. then change the bulb and put back together
the sensor is part of the fuel pump assy and comes out through a hole underneath the matting in the trunk.... remove the cover and remove lines from assy and then remove assy from tank.....make sure to relieve pressure from fuel lines before you remove lines due to residual pressure in the lines...
There is an orifice in the primer assy. in the carb. that is plugged. You will have to remove and clean the primer assy.
I believe the handle is one whole assy handle holder and lever. remove door panel and assy should rivet/bolt to door
when i removed the heater for my nova i had to disconnect the cables and wires from the heater assy and on the engine side of the firewall remove the nuts holding the assy to the firewall that allowed the whole assy to come out from under the dash then i dissassembled the assy and the heater core was bolted into the assy on the ends hope this helps
Under the vehicle on the driver side by the drivers door next to canister assy.
I have a 92 PA. I had to remove the head light assy which gave access to that bulb. There are two thumb like screws to remove that assy. Hope yours are the same as mine.
there is a nut on the left side of the light on drivers side,just the opposite on passenger side. you will need a deep socket. there are 2 10mm bolts on top of the assy. and on the back is a 10mm nut you will have to remove on order to remove the assy.
remove three boltes from case the whole assy will slide out
remove wheel remove brakes/caliper/caliper bracket/rotor remove cotter pin/axle nut remove 4 bolts from wheel bearing assy unplug electrical connector for ABS, if has it tap axle end lightly to dislodge fron wheel bearing assy may need pry bar and hammer or air chisel to remove wheel bearing assy from vehicle clean orifice well and installation is the opposite