0
The first step is removing the tires from the vehicle. Then the brake calipers will need to be removed. Once the calipers are off, take the cap off the area in the center of the rotor. This will give you access to the nut holding the rotor on. Removing the nut on the spindle gets the rotor off.
What else can I help you with?
Are there any fasteners holding the rotors onto the front axle of a 2003 Pontiac vibe?
No fasteners holding rotor on. But you must remove caliper and caliper mounting bracket first.
Where is the horn on the 2005 Pontiac vibe?
The horn on the 2005 Pontiac Vibe is located in the front of the vehicle, typically behind the front grille. It is mounted on the driver's side, near the radiator support. To access it, you may need to remove the grille or other components depending on your specific model and configuration.
How do you replace Pontiac vibe front wheel bearings?
The front wheel bearings, of a Pontiac vibe, can be replaced by first removing the front wheel. Next, remove the axle end cap. Remove the bearing and reverse the process to install the new bearing.
How do you remove the brake drum from a 2005 Pontiac vibe?
http://forums.genvibe.com/zerothread?id=26369
How do you replace an ac fan resistor in a 2005 Pontiac Vibe?
passenger side under glove box...you don't have to remove glove box to get to it...generation vibe forum has clear photos
What are the release dates for City Vibe - 2005?
City Vibe - 2005 was released on: USA: 3 October 2005 (Los Angeles, California)
Where is the oil drain plug located on a 2005 Pontiac vibe?
where is the plug to drain the oil in a 2005 Pontiac vibe
What are the minimum brake rotor specification foa a 2007 pontaic vibe?
For a 2007 Pontiac Vibe, the minimum brake rotor thickness specification is typically around 24 mm for the front rotors and 10 mm for the rear rotors. It’s essential to refer to the vehicle's service manual or a trusted source for exact specifications, as these can vary slightly based on the model and brake system. Always ensure that rotors are replaced or resurfaced when they fall below these minimum thickness levels to maintain optimal braking performance.
How do you remove back seat Pontiac Vibe?
My 2003 Vibe has a split rear seat and each of these seats has 2 bolts at the front of the cushion. Simply unscrew these 4 bolts and lift up at the front of cushion. Needed this to clean out garbage which lodges under seat.
Where is the aux in a 2005 Pontiac vibe?
There is no aux in on the 2005 Pontiac Vibe. There is a button the says aux but the radio in fact has no aux it.
What actors and actresses appeared in City Vibe - 2005?
The cast of City Vibe - 2005 includes: Branden Williams as Host
Where is the fuel pump located on a 2005 Pontiac vibe?
The fuel pump on a 2005 Pontiac Vibe is located inside the fuel tank. To access it, you typically need to remove the fuel tank from the vehicle, as the fuel pump is not accessible from the top. It's advisable to relieve the fuel system pressure before attempting to remove the tank for safety reasons.
