To remove the headlight clips on a 2002 Grand Am, start by opening the hood and locating the clips that secure the headlight assembly. Use a flathead screwdriver or a similar tool to gently pry up the clips, being careful not to break them. Once the clips are loosened, pull them out completely, and you can then detach the headlight assembly from the vehicle. Remember to disconnect the wiring harness before fully removing the assembly.
The radiator fan relay has failed. The relay is under the front bumper cover under the right front headlight. The easyist way to access the relay is to remove right front headlight and drill a 1.5 inch hole to remove. Otherwise the entire front bumper has to be removed.
Do the Clips was created on 2009-02-18.
One Headlight was created on 1997-02-24.
Kara Best Clips was created on 2011-02-23.
On an 02 There are 2 VERY small allen screws under the housing. Remove them and turn the lens counter clockwise.
Jean-Luc Grand-Pierre was born on 1977-02-02.
pass side radiator not all the way down on the side. i think you can get at it if you take the light bezel off the right headlight. 4 scews has the turnsignal light in it. ...actually, remove the grill, not the light bezel.
Door Panels Removal & Installation 1. Remove the sail panel. 2. Remove the door panel by carefully lifting the panel upward to release the retaining clips. 3. Remove the electrical plugs that control the windows, exc. 4. The installation is the reverse of the removal.
how to replace headlight and bulbs 98-02 mercury villager
Grand Duchess Maria Kirillovna of Russia was born on 1907-02-02.
You must remove the four screws that hold in the side marker lenses (two per side/lens) pull the lens forward & out to the side. Next remove the grille, to do this you need to push in both top & bottom of the plastic clips that hold it in place. These clips usually break since they are old (1995) & made of plastic. Each clip costs $1.99 from the Toyota dealership (for .02 cents worth of plastic!) you will probably need a few even though they are way overpriced. Then once the grille is removed you can remove the four bolts that hold the lens assembly in place, once it is removed you unplug the bulb & then unscrew the plastic retaining ring that holds the bulb in place & remove the bulb from the housing. Installation is the reverse of removal - BEWARE; do not touch the glass of the bulb, oil from your skin will cause hot spots on the glass & lead to premature failure of the bulb. If you do happen to touch it, clean the bulb with alcohol prior to assembly. Method #2; remove the air box on the drivers side (behind the headlight & you can remove the bulb from the back. On the passenger side, remove the battery & the washer fluid reservoir & you can remove it from the back also. Either method is time consuming & an unusually bad hassle for something as routine as changing a headlight.
Otis Grand was born on 1950-02-14.