The push pins that are holding trim to the front bumper on a 2001 Silverado are actually pop rivets. These rivets have to be cut off to remove them. A hacksaw will be needed to accomplish this.
Unscrew it.
Two ways. Either remove the bolts holding the bumper to the brackets, or remove the bolts holding the brackets to the frame and remove them with the bumper. Make sure you unplug the turn signal lights as well. It's pretty simple and straight forward.
== # Release hood latch and open hood. # Remove grille # Disconnect headlamp wire connector and remove headlamp module # Remove front fascia # Disconnect park/turn lamp wire connector. # Remove inboard and outboard bolts holding front bumper to frame # Carefully separate front bumper from vehicle
Unbolt the front of the wheel well liner inside the wheel opening.Remove the bumper cover bolt from the bracket located inside of the bumper at the end.AT the front of the car, remove the bolts holding the bumper cover on, located underneath the vehicle.You should now be able to remove the bumper cover from the front of your Dodge Intrepid.An instructional video has been included to show you the removal process.
you haft to remove the bumper first to get to the bolts holding in the lights
how to remove front bumper on citroen berlingo
how to remove front bumper 2002 Impala
Usually to remove the front bumper grill you would just locate the screws or bolts holding the part in place and then remove them. The grill should be able to be removed after that.
YES.
do i have to buy the brackets wit the bumper when i buy it
no
To remove the front grill on a 2007 Chevrolet Tahoe the bumper will need to be removed first. After the bumper is removed, take off the four screws and clips holding the grill in place. The grill is then ready to remove.