You can go on this website they have lots of information and videos on DIY. this is the link for the stereo replacement : http://www.infinitihelp.com/diy/gsedan/projects/infiniti_g35_radio_replacement_procedure.htm
To remove the factory stereo on 1996 dodge ram 1500 you need to pop the hood on the Ram and remove the ashtray. Slide the stereo out of the dash and unplug the cables from the back of the stereo.
The stereo can be removed by first removing the dash cover. On the bottom side of the cover that is in front of the stereo are two screws. Remove them, and then use two large, flat screwdrivers (wrapped in a soft cloth to protect the dash) to carefully pry off the cover.
1. from bottom of trim panel around stereo pull from dash. 2. pull panel down to release latches at top. 3. remove 4 screws securing car stereo and pocket to dash. 4. pull car stereo forward, disconect antenna and connectors.
www.crutchfield.com they come with dash kit and wire adapters at no extra cost. A big plus!
The real answer: Remove the stereo from the dash board and disassemble it to release the disk. I had a new stereo so I used a hammer and a big screw driver the last time I had to do this.
Ihave 2000 grand prix how to remove dash board to remove radio Go to http://www.carstereohelp.com/stereoremovalPontiacGrandPrixSt2.htm
put the parking brake in, then put the truck in 1st gear pop the dash cover off and then remove bolts from stereo.
I need help removing my dash to get to the back of my stereo on my 2006 dodge ram 1500
there will be roughly 4 screws on the dash, 2 by the guage window and 2 by the radio/ heat controls. after removing pop out the dash. you will have to lower the steering collum, after the dash is off you have 4 screws holding the stereo in place.
The molding around the dash area where the stereo has several hidden screws up under the cross pieces. Remove those and it should pop off. From there the stereo has 4 screws that hold it in place.
To remove the dash you simply use a thin tool and insert it between the dash where the stereo is mounted and the rest of the dash. this will take off the entire section with the AC vents, the AC controls, the clock and the stereo. After you get a portion of it off, gently pull the rest of the dash off. The dash is held to the rest of the dash by spring loaded clips, so if you are careful you won't break anything.
To remove the factory-fitted stereo from a Daewoo Cielo, start by prying off the trim panel surrounding the stereo using a flat tool or a trim removal tool to avoid damaging the dashboard. Once the trim is removed, unscrew the mounting screws securing the stereo in place. Gently pull the stereo out of the dash, disconnect the wiring harness and antenna cable from the back of the unit. Finally, make sure to keep all screws and connectors safe for reinstallation or replacement.