answersLogoWhite

0

The distributor is a single unit. Set the engine to top dead center. Make a witness mark on the distributor body and the engine case to reassemble and re-align the unit. Remove the distributor clamp holding the distributor in place. Remove and mark the wires. Pull the distributor straight up and out of the engine case. The shaft is keyed and should be in the body of the distributor. Reassembly is the reverse procedure.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you remove a distributor drive shaft on a vw beetle engine?

Two choices: use the special distributor drive puller, or take the engine completely apart. I recommend the puller.


How do you change pickup coil on a 1988 GMC 2500 pick up?

Remove Distributor,remove drive gear,remove shaft,remove pickup coil.


Which shafts are present in a car?

Axle shaft, steering shaft, drive shaft, distributor shaft


How do you take apart the distributor on a 1986 Chevy Celebrity 2.5L engine?

To dismantle the distributor already off of the engine: 1. Mark the position of the drive gear on both the gear and the shaft so they can be put back together in the same location. 2. Support the body of the distributor and using a suitable drift punch the drive pin out of the gear and shaft and remove gear. 3. The shaft will now come up through the distributor housing, and is essentially taken apart. 4. To remove the pickup coil remove the clip that holds it in place and take it out. 5. To remove the ignition module take out the screws.


Does the magnet on the distributor shaft slide off?

The distributor will need to be removed. The magnet is permanently attached to the distributor shaft and the shaft is held in place by a roll-pin thatpasses through the distributor drive gear on the bottom side of the distributor. Magnet on top, gear down in the engine, distributor shaft and housing in the middle.


Where is the oil pump on a 1998 Jeep Wrangler?

Inside the engine oil pan, at the bottom of the distributor drive shaft.Inside the engine oil pan, at the bottom of the distributor drive shaft.


Do you have to remove the distributor to replace the stator in a 90 Chevy 350?

Yes you do. You have to take the distributor shaft out of the distributor to Remove the pick-up coil / stator.


How do you change a Fiat Doblo drive shaft?

how to remove a drive shaft on a fiat doblo


How do you remove a drive shaft in 1999 Ford Taurus?

there is no drive shaft it's front wheel drive


How do you remove a Pick up coil on a 1992 Geo Storm?

Remove the distributor from the engine by completely. Record the postions of the rotor and base BEFORE removal. Drive out the pin at that holds the drive 'gear' ontot the distributor shaft. The rest of the distributor disassembles from the 'outside'. Several bolts hold the coil assembly in place. Replace all of the O-rings when re-assembling.


Dodge Durango rear drive shaft removal?

How do you remove drive shaft from a 03 durango


How do you remove broken off flexible drive shaft from weedeater?

remove head pull shaft out