1. Carefully pry-up the door lock escutcheon trim.
2. Carefully pry-up the window/mirror switch assembly in the door armrest, taking care not to damage the locking tabs;
3. Disconnect the two wiring harness clips for the mirror and the power windows; set the switch assembly aside.
3. You will find (2) phillips screws accessible through the hole created by the mirror/switch removal; unscrew them.
4. Carefully pry-off the rectangular escutcheon around the chrome door release.
5. In the bottom of the finger cup of the armrest, you will find two round rubber covers-pry them out;
6. Unscrew the two phillips screws revealed under the two rubber covers;
7. Grab the bottom of the door panel, pulling away at a 90 degree angle from the door, working from the bottom to the top;
8. Upon reaching the top release of the panel, pull upward and free from the metal door skin.
9. Upon re-attachment, re-set the plastic expansion studs to ensure relatively complete attachment, as some may have broken.
10. Reverse to re-attach
11. Good Luck!
Remove center stack bezel (radio, heater control), remove screws from instrument trim panel at ctr stack and remove instrument trim panel, remove dash top panel, replace speakers.
To replace the back speakers in a 2006 Acura TL, remove the SRS housing on both sides and the back panel of the speakers. Remove all wiring attached to the speakers and replace.
Front speakers are in the door. remove screws on the door panel, then remove the panel and you'll see the speaker
Remove door panel, remove 4 screws, remove speaker, put new speaker in, replace screws, replace door panel. Done.
you have to remove the door panel
How do I remove the front door panels on a 1996 Infiniti G-20. I am trying to install new speakers
In order to replace the speakers you have to flip down the rear seats and look at the screw ports and remove all the screws to remove the panel covering the speakers. The rest is self explanatory.
You have to remove the door panel, after that you will be able to replace the speaker.
Yes the door panel must be removed to gain access to the speakers. Just replace them It will sound better.
power door or manual
link here: http://www.craigcentral.com/durango/speakers.asp
# Remove the door trim panel # Remove the mounting screws withdraw the speaker unplug the electrical connector and remove the speaker