Jack the front of the car up and crawl under it and you will see how the fog lights unbolt.
http://forums.maxima.org/infiniti-i30-i35/589286-how-remove-fog-lights-96-99-i30.html
Fog lights burn out pretty fast, especially those high intensity ones. (A few months)-I own a '97 trans am as well.
To replace the fog lights on a 1995 Trans Am, first, ensure the vehicle is turned off and the keys are removed. Remove the screws or clips holding the fog light assembly in place, then carefully pull the assembly out. Disconnect the wiring harness from the old fog light, replace it with the new bulb, and reassemble everything by reversing the steps. Finally, test the fog lights to ensure they are functioning properly.
Fog lights are only accessable when headlights are on; once headlights are on, pull shaft/stalk out to turn on fog lights.
To install fog light in a 2000 Trans Am, disconnect the fog light switch from the housing. Then remove the washer, bolt, and nut. Finally, remove the fog light housing, twist the fog light off, and replace. ?æ?æ
Ebay
To turn on the fog lights in a 1999 Toyota Solara, first, ensure the headlights are on, as the fog lights only operate with them activated. Locate the fog light switch, which is typically part of the headlight control stalk on the steering column. Rotate or pull the switch to the fog light position, and you should see the fog light indicator on the dashboard illuminate, confirming they are on.
The fog light switch is in the center stack of your dash , just to the right of the radio , near the bottom of the radio . Just push the button to turn on the fog lights and push it again to turn off the fog lights
How do i change the fog lights on a 2005 Kia Sedona? Answer Behind Your Fog Lights Remove The Nut's And Bolt's Can't Go Wrong With Wireing The Wires Are Different Colors
Remove the fog light retaining bolt. Remove the fog light wiring harness. The fog light will come out. Reverse the process to install the new fog light.
To remove the fog lights on a Vauxhall Corsa, first, ensure the vehicle is turned off and parked on a flat surface. Access the fog lights from underneath the front bumper; you may need to remove any protective covers or screws. Disconnect the electrical connector, then twist or unclip the fog light housing to remove it. Finally, replace it with a new unit if necessary, ensuring everything is securely reattached.
To add fog lights to a 1999 Miata, you'll need to purchase a fog light kit compatible with the model. Start by mounting the fog lights to the designated brackets or underneath the front bumper. Next, wire the lights to a switch inside the cabin and connect them to the vehicle's electrical system, ensuring to use a relay to prevent overload. Finally, test the lights to ensure proper functionality and alignment.