answersLogoWhite

0

two VERY SMALL flathead screwdvrs, one on the left and one on the right of switch. Push and pull like with chopsticks. I removed and cleaned connectors in this switch of my '87 190e and "fixed" the sunroof Do not be afraid of ball bearings and springs inside switch. Here is their order, bottom to top: first the metal rocking plates, then bearing on top and then springs that fit instide posts on top (cap) peice of switch.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

Where is the switch to open sunroof on 1984 190E Mercedes?

There are two possibilities. Its either on the overhead console by the rear view mirror or on the center dash control switches below the heater vents.


How do you replace the seat switch on a 91 Mercedes 190e?

To replace the seat switch on a 1991 Mercedes 190E, first, disconnect the car battery to ensure safety. Remove the seat by unbolting it from the floor, then gently lift it out. Locate the seat switch, disconnect the wiring harness, and unscrew the switch from the seat. Install the new switch by reversing the process: attach the wiring harness, secure it in place, and reinstall the seat before reconnecting the battery.


How do you remove cylinder head from 1991 Mercedes Benz 190e 2.3?

how remove cylinder head


How do you replace ignition 0n 1990 190E Mercedes-Benz?

To replace the ignition switch on a 1990 Mercedes-Benz 190E, first disconnect the battery to ensure safety. Remove the steering column covers to access the ignition switch. Unscrew and disconnect the old ignition switch from the wiring harness, then install the new switch by reversing the process, ensuring everything is securely connected. Finally, reassemble the steering column covers and reconnect the battery.


Mercedes 190e 1985 window switch dead?

my 1993 190E 2.3 is doing the same thing. just replace the switches...they tend to not last


Why would the electric seat tilt forward but not back in a 1992 Mercedes 190E?

It's probably the switch.


Where is the brake switch on a Mercedes 190E?

The brake switch on a Mercedes 190E is typically located above the brake pedal, mounted on the brake pedal assembly. It is usually positioned close to where the pedal arm connects, allowing it to be activated when the pedal is pressed. To access it, you may need to remove some trim panels under the dashboard. Always consult the vehicle’s service manual for specific details and procedures.


190e sunroof leaking water?

Drains are clogged


What do you do if the sunroof on a 1985 Mercedes 190E opens but will not close?

on my 1984 190e there is a nut that can be turned with the tools that came with the car.. the nut is located behind a plastic cover in side the trunk on the left side, near the left trunk hinge. but if the cable is broken, this may not work If roof opens then motor & cable are obviously functioning. Suggest checking switch. Also when switch is set to close can u hear sound coming from sunroof area: if yes then switch ok. My problem is opens fine but gets stuck when closing, and will only close by "pulsing " the switch, which would seem to suggest problem with the slide rail(s).


How come the overhead light does not come on in a Mercedes 190E The fuses are fine and the light is fine.?

Switch may be bad


Where is the power seat switch on a 1992 Mercedes Benz 190E 2.6 driver side?

Its on the door panel next to the door handle. at least that's where it is on my 1992 190e 2.3


Where is the neutral switch on 190e 1986 Benz?

The neutral switch on a 1986 Mercedes-Benz 190E is typically located on the transmission. Specifically, it can be found on the side of the transmission housing, near the gear selector linkage. This switch is responsible for indicating when the transmission is in neutral, affecting the starting system and other functions. To access it, you may need to lift the vehicle and remove any protective covers.