You can't. It is computer controlled. Actually, that's not necessarily true.... All you need is a Chilton's manual to trace the location of the vehicle speed sensor (VSS) wire, which goes to your ECM. Find the wire, clip it and splice in a toggle switch to your dashboard, then run the wire back to the other side of the wire you snipped. Switch off, the VSS is disabled and probably, you will get a computer code or some check engine light that will come on. No big deal, after you do the dirty deed of speeding above and beyond what all of us disapprove of, just switch your toggle back on and POOF! Your VSS works again! (Sorry boys, I'm a gearhead...) Steelman1196 you need to buy a programmer from hypertech. you can get rid of a governor, adjust you're timing, adjust you're speedo for different size tire, regulate the fuel/air .....ect. 20-30 extra horses! depending nick Actually, that's not necessarily true.... All you need is a Chilton's manual to trace the location of the vehicle speed sensor (VSS) wire, which goes to your ECM. Find the wire, clip it and splice in a toggle switch to your dashboard, then run the wire back to the other side of the wire you snipped. Switch off, the VSS is disabled and probably, you will get a computer code or some check engine light that will come on. No big deal, after you do the dirty deed of speeding above and beyond what all of us disapprove of, just switch your toggle back on and POOF! Your VSS works again! (Sorry boys, I'm a gearhead...) Steelman1196
It is not recommended by the manufacturer to remove the speed limiter on a Fiat Doblo. The speed limiter is installed for the safety of the vehicle operator.
To remove the speed limiter on a 2006 Buick Lucerne, you typically need to reprogram the Engine Control Unit (ECU) using a specialized tuning tool or software. This process may involve connecting the tuning device to the vehicle's OBD-II port and adjusting the settings to disable the speed limiter. It’s important to note that modifying the speed limiter may void warranties, violate local laws, or compromise vehicle safety, so proceed with caution and consider consulting a professional.
Replace your CDI
95 mph.
It is controlled by the ECU, which you cannot remove.
yes the top speed of a 1994 buick skylark is 112mph it has a rev limiter or what most people call it a governer.
DO you know what the top speed of this car is?
How can you get to the tcc sensor on a 2000 buick lesabre 3.8 and can a speed sensor trigger a code for the tcc
I heard some people remove a fuse which will kill many things including the speed limiter but that isn't really safe. The better solution is to get a unichip which would in the same time add some horsepower as well as removing the speed limiter
You have to reprogramme the motor's ECU.
buy a SLD speed limit defender.. wire in job....
To install a speed sensor on a 1992 Buick LeSabre, first disconnect the negative battery cable to ensure safety. Locate the speed sensor, which is typically found on the transmission housing. Remove the electrical connector and the retaining bolt for the sensor, then pull the old sensor out. Install the new sensor by reversing the removal process, securing it with the bolt, reconnecting the electrical connector, and finally reconnecting the battery.