Drain oil from primary. Remove pedals. Unscrew primary cover. Take off retainer cover piece evenly. Take off retainer clip. Pull the clutch out using the bolts and there you have it! Remember the order they came out and make sure you install them correctly. Doesnt hurt, actually you will need a second set of hands to push the retainer cover back on due to the extremely strong springs underneath if you do not have a pulley puller.
if ya do it yourself bout 270.00 a shop 430.00
A 1977 Harley Sportster has a 3 qt capacitie
There's a clutch on the starter that acts like a Bendix gear on a car. This clutch is stripped out on your bike. You'll need to pull the starter to replace it.
I have a 1977 Ironhead Sportster XL and it's the standard 1000cc.
A clutch not disengaging is usually a hydraulic issue. Check your clutch fluid. Then check your clutch master and slave cylinders for leaks.
unleaded premium
through the clutch inspection cover
Replace clutch cable on sportsbike
A whirring noise coming from the clutch area of your 2009 Harley Sportster could indicate several issues, such as a failing clutch bearing, a misaligned or worn clutch component, or low or contaminated clutch fluid. It's essential to inspect the clutch assembly for any signs of wear or damage, as these issues can affect clutch performance and lead to further complications if not addressed. If you're unsure, it's advisable to consult a professional mechanic for a thorough diagnosis and repair.
through the clutch inspection cover
most likely you need the clutch paw replaced in the tranny.
what is cost to replace a clutch in a BMW Z3