answersLogoWhite

0

just found my leaky heqter matrix had to remove all the bottom of the interiar dash the them un bolt the gear stick unbolt the whole heater system disconnect the hoses from the engine bay and wiggle the whole unit out then take the matrix out .it s a pig still got to put it all back again

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

When was Peugeot Boxer created?

Peugeot Boxer was created in 1994.


How do you replace front wheel bearing peugeot boxer do you need a bearing puller?

Get a manual for this vehicle.


How do you check gearbox oil level on Peugeot boxer?

how do you check the oil in peugeot boxer '05 2 litre hdi


Where is the Peugeot boxer speed sensor?

The speed sensor on a Peugeot Boxer is on top of the gearbox. It is near the driver's side drive shaft inner CV.


What is the Peugeot boxer oil capacity?

My 2005 Boxer 2.8 HDI has a capacity of 7 litres.


Where is fuse for rear lights Peugeot boxer van?

Fuse for rear lights on boxer van


How do you set a clock on a peugeot boxer van?

You can set or adjust the clock on a Peugeot Boxer van by pushing on the little buttons below the clock using a pen point.


How much do Peugeot Boxer vans cost?

A Peugeot Boxer van can be a very expensive purchase. One might find individual pricing on these vans at the official "Peugeot" website or at the United Kingdom "Auto Trader" website.


Why will my Peugeot boxer 2005 immobilizer light not go out?

If an immobilizer light on a 2005 Peugeot Boxer will not go out it indicates a problem with the wiring. The immobilizer can be by-passed until the wiring can be checked.


How do you change the headlight bulb in a peugeot boxer van?

You will first need to get the right bulb--do this by checking the users manual. You can then take out the old bulb and replace the new one.


What is the oil capacity for a peugeot boxer 2.2 gearbox?

.5 litres


Peugeot boxer immobilizer byepass?

what year is it 2000 what cc is it?2400