0
If it's the same as a 1991 it's easy. Just take off the switch itself (it will pull out of the door with some effort) Try not to break it.. If you want to be a little more careful just pull off the entire plastic plate that contains the switch, door handle, and power lock buttons. Carefully pull from the bottom until the bottom latch comes off then keep going up with the part and insert your hand behind it so you don't break the plastic. Once you get the plate all the way off then you just unscrew the circular safety from the back of the switch take the switch out by putting pressure on the plastic piece (from behind the switch) on top of the switch and push from the back.. once you get it through the hole in the plastic (so it's inside the car) then just slide the plastic part with the wires out from the back of the switch then insert the new switch and put the pieces back on in which you took them off. I used 0 tools to do this on a 1991 so good luck. est time 5-10 mins
What else can I help you with?
How do you replace driver side window in 1993 Chevy astro van?
How do i change the window on a 95 chevy astro van
How do you get your power windows to work in your 1994 astro van?
To get your power windows to work in your 1994 Astro Van, first remove the interior door panel. Now you can access the actuator, the window switch, and the window motor. Replace the broken part in order to make the windows work again.
How do you replace an ignition switch for a 1977 Chevrolet truck?
n ignition switch on a 1991 Chevrolet astro vanAnswern ignition switch on a 1991 Chevrolet astro van
What gasoline use astro 98 van?
the 1998 Chevrolet Astro Minivan is the van that uses gasoline.
How do you replace a 4 way flasher on a 1986 Chevy Astro Van?
It is quite simple to replace the four-way flasher relay switch in your 1986 Chevrolet Astro Van. The four-way flasher relay switch simply plugs in and out.
How do you replace roll up window in 94 astro van?
To replace the roll-up window in a 1994 Astro Van, first, remove the interior door panel to access the window mechanism. Disconnect the window regulator and any attached components, then carefully slide the old window out of the channel. Insert the new window into the channel, reattach the window regulator, and reassemble the door panel. Finally, test the window to ensure it operates smoothly.
How do you replace the ignition switch on a 2002 Chevy Astro van?
You will need to remove the ignition switch retaining ring in your 2002 Chevy Astro Van. Slide the ignition switch out. Remove the wiring harness from the end of the ignition switch. Reverse the process to install the new ignition switch.
How do you replace ignition switch astro van?
To replace the ignition switch in an Astro van, first disconnect the negative battery cable to ensure safety. Remove the steering column covers by unscrewing the screws and clips. Then, locate the ignition switch, which is typically mounted on the steering column, and disconnect the wiring harness. Finally, unbolt the ignition switch, replace it with the new one, and reassemble the column and reconnect the battery.
Where is the voltage regulator on a 1997 Chevy astro minivan?
The voltage regulator is built into the alternator.
Why would only the passenger side window work on a 1996 Chevy astro?
Bad switch or motor on other window Check to see if you are getting power to it - if so bad motor - if not maybe bad switch or open in wiring circuit
How do turn off the parking brake light in 1990 Chevy Astro?
When the brakelite switch fails it fails to on. Replace the brakelite switch. Located under the dash on the brake pedal arm. You will see a push switch that is released when the brake is pressed. Just replace that switch.
How do you replace the driver side sliding glass window in a 1997 Chevy astro van?
remove the inner pannel. That will put you at the assembly. with windo up, remove assemblt. then replace
