I was at the Fleet Pride in Kirkwood, NY yesterday looking for a new set of hubs for my '01 F350 Dually and all of their part numbers were the same for the older style axle (70's-97-8ish) and the newer super duty trucks and they brought a set of Mile Marker hubs out for me to look at and they were for the older style axles when they started making the new super duty style trucks in the late 90's there were some changes made they had a metric wheel stud pattern metric studs and nuts and automatic vacuum operated hubs that were also able to be locked in manually by turning them 1/4 turn they also changed the way they were installed the new hubs instead of having 6 allen screws (or 3 allen screws on some models) to hold them they were pushed into the hub housing and just had a snap ring that held against the outer edge of the hub itself with no additional hardware so if they have the allen screws they will not work on an 01 and good luck finding them other than at a dealer dually these hubs are different than hubs on single rear wheel vehicles and the only ones I have heard of on forums or anything are Warn they are manual and pics show hubs with 6 pieces of hardware so I dont know about them either the hubs for my Ford are $301.00 each here so good luck.
How do you replace 2001 Mercedes c320 front marker light
I took a few screws out of the front wheel well mud guard behind the marker light and reached in through there to remove and replace the side marker light.
The towing capacity of a 2001 Ford F350 dually diesel 4x4 truck is 8,250 pounds. This allows the truck to safely transport all but the largest trailers and boats.
it depends on if it is a common rail or not but they are quite easy to do if you have the locking kits for the cam shafts or not
Answer: The dealership is correct. The 2001 XJ does not have a steering column locking mechanism.
Open the hood. On the headlight housing you will see a locking cam. Depress and release. The whole assy will be pulled from the front of the car. Once out you will see how to replace the bulb(s)
* Raise the car and suitably support it on jackstands * From below you can access both the turn signal and side marker lights * The side marker bulb holder pulls straight out of the socket and the turn signal bulb holder must be rotated to remove it
No not to replace the fuel pump. It is under the rear seat access door. Then you take a wooden dowel and turn the locking ring counterclockwise.
they are aproxametly 7,000 pounds depending on how they are equiped
Replacing disc brakes can be a tricky task. First, you must make sure they are cool enough to touch, then bleed them and take apart the brakes. You can put new pads and discs on to finish the job.
The passenger side front marker light can be access from the back of the light. Take hold of the connector, push in and turn at the same time. The light will come out. Reverse the process to install the new light.
You can program a 2001 Chevrolet Camaro by locking then unlocking the door locks.