To replace spark plug wires on a 3300 Oldsmobile engine, open the hood and remove the wires from the end of the engine. The number of spark plug wires most often corresponds to the number of cylinders your engine has.
Disconnect the battery, remove the engine cover, remove the spark plugs wires and boots, and remove the spark plugs. Put in the new spark plugs, replace the spark plug wires and boots, replace the engine cover, and connect the battery.
Replace spark plugs, wires, air filter, fuel filter, spark plug wires and PCV valve.
Flush and replace the engine coolant. Replace the engine timing belt or chain. Replace the spark plugs & wires.
did you replace the spark plug wires?
The 2002 Honda Civic EX engine uses coil-on-plug. There are no sparkplug wires.
You need to replace your spark plug wires!! You can check this by spraying water on your spark plug wires when it is dark. Then start your engine and you should see the wires arc and your engine will be running rough just as it does when it rains or after a rain. Good Luck
To tune up your Celebrity's engine: Replace the spark plugs, gap is 0.045". Put on new spark plug wires.
you need to buy spark plugs and spark plug wires first. Buy a spacer so you can replace the spark plug back into the hole correctly. First, take the spark plug wires off the spark plugs BUT NOT OFF THE DISTRIBUTOR CAP!!! Then, put the new spark plugs in using the spacer and ratchet. It doesn't matter which spark plug goes where. (wrench, pliers, whatever). Next replace ONE WIRE AT A TIME so as not to mess up the firing mechanism. Make sure you replace the wire in the exact position as the old one was. Otherwise, if replaced incorrectly, the engine will fire each piston at different times. Then, start the engine. If your engine starts to gurgle or sound funny and vibrates, that means you have incorrectly replaced the wires and you need to switch the order of the wires. If the engine is running properly, good job!
To replace the spark plugs from a 2004 Kia Sedona the plug wires ,must be removed from the engine. Unscrew the plugs. Properly space the new plugs and screw them in.
A diesel engine doesn't have spark plugs or spark plug wires.
ballast resistor on the firewall, it's a porceloin block with wires going to it, replace it.
Spark Plug wires connected incorrectly, or engine is out of time.Spark Plug wires connected incorrectly, or engine is out of time.