I'm assuming you meant "1/3 HP" as Little Giant doesn't make a 13 HP model.
There is a small black circle plug on the outside of the pump body with 4 holes dimpled in its surface. That's the oil fill port. You can turn it carefully using the points of a set of needle-nose pliers or snap-ring pliers. BE CAREFUL not to damage the plug, you're going to need to reuse it. It's sealed with a small o-ring (generic o-ring size '012'). Drain the old oil from there, then fill slowly thru the same port. There is a small amount of airspace required inside the motor so don't fill the motor completely full of oil.
If the oil needs replacing, there's probably another problem with the pump that needs to be addressed as well.
To replace a sump pump battery, first, disconnect the old battery and remove it from the sump pump. Then, install the new battery by connecting it to the pump following the manufacturer's instructions. Finally, test the sump pump to ensure the new battery is working properly.
To replace the float switch on your sump pump, first, disconnect the power source. Then, remove the old float switch by disconnecting it from the pump. Install the new float switch by connecting it to the pump. Finally, test the sump pump to ensure the new float switch is working properly.
For a Little Giant sump pump, it's recommended to use a lightweight oil, such as 10W-30 or 20W-20 motor oil, for lubrication. Always check the manufacturer's guidelines for your specific model, as oil requirements may vary. Ensure that you avoid using heavy oils that can cause the pump to operate inefficiently. Regular maintenance, including oil changes, is crucial for optimal performance.
Yes. Float-type and diaphragm-type are both available as a piggy-back to your power cord and will work with most common sump pumps. Search 'Little Giant', 'SJE Pumpmaster' , etc. You'll have a good start with those.
You would need a sump pump repair if the sump pump in your basement is not pumping out water. The purpose of a sump pump is to drain excess water that is part of your waterproofing system.
Without knowing more details about the type and location of the sump pump it is hard to advise you what to do. If you can log in again and provide more details someone may be able to give you a more helpful answer.
The purpose of a sump pump vent is to release air pressure from the sump pump system, allowing water to flow freely and preventing airlocks. This helps the sump pump operate efficiently by ensuring proper drainage and preventing clogs or malfunctions.
A sump pump drains water from a sump pit or basin located in the lowest part of a basement or crawlspace.
Your sump pump float may be stuck due to debris or a malfunction. To fix it, first check for any obstructions and clear them. If that doesn't work, you may need to adjust the float switch or replace it if it's damaged. It's important to address this issue promptly to ensure your sump pump functions properly.
The best options for a sump pump cover square to protect your sump pump system include durable plastic covers, metal covers, and custom-fit covers. These covers help prevent debris from entering the sump pump system and ensure proper functioning.
The purpose of a sump pump bucket is to collect water that enters the sump pump system. It helps prevent flooding by holding the water until the pump can remove it. The bucket also helps keep the pump from running too frequently, which can extend its lifespan.
For shear enthusiasm about sump pumps, it is hard to beat Sanders Plumbing, "The Sump Pump" experts--501-588-0969. But, the Bug Man of Little Rock also delivers sump pumps and dry crawl space solutions-- 1-800-341-6730.