0
What else can I help you with?
How do you replace a vs commodore ute fuel pump?
To replace the fuel pump, you firstly need to remove the fuel tank. Then you will be able to remove the fuel pump and replace it. Service repair manuals start at around $20 on eBay, and are a worthwile investment if you intend to carry out your own repairs. They are an absolute must if you have little or no experience.
How do you change VS commodore brakes?
how do I change the pads and rotors on a VS Commodore ?
When was Holden VS Commodore created?
Holden VS Commodore was created in 1995.
What is the spring next to oil filter on vs commodore?
It is the same as summer but just a little colder in Brisbane.
Your VS commodore is srarts and within five second going off?
Replace the fuel filter, it may be plugged.
How do you adjust rear band on transmission for a vs commodore 6hdd?
How do you adjust rear band on transmission for a vs commodore 6hdd?f
How much should a new fuel pump for a VS commodore cost including labor?
$77 from Scotts auto-one and $150 to fit -----Auto Electrician
What are rockers on a VS commodore?
They are the aliens from planet marlboro
How to replace handbrake leaver in vs commodore?
To replace the handbrake lever in a VS Commodore, start by removing the console cover that surrounds the lever. This typically involves unscrewing any fasteners and carefully prying it loose. Next, disconnect the handbrake cable from the lever and remove the retaining bolts. Finally, install the new lever by reversing the process, ensuring the cable is properly connected and the console is reassembled securely.
What is the head bolt tensions on a V6 VS Commodore?
the answer is 56
Where can i find a wiring diagram for a vs commodore dash?
You can find a wiring diagram for a VS Commodore Dash inside the owner's manual. You can also check with local auto part stores.
How do you replace sway bars on vs commodore?
To replace sway bars on a VS Commodore, first, lift the vehicle and secure it on jack stands. Remove the wheels for easier access, then unbolt the sway bar from its mounting points on the chassis and the control arms. Replace the old sway bar with the new one, ensuring all bushings are properly lubricated, and reattach it securely. Finally, reassemble the wheels, lower the vehicle, and perform a test drive to ensure proper installation.
