no reset needed,just replace the brake pads sensors
How do you replace the wiper blades on a 2006 Mercedes C230 Sport
where can find the phone jack in 2006 mercedes benz c230 thanks
To reset the check engine light on a Mercedes C230, you can use an OBD-II scanner to clear the codes. Simply connect the scanner to the OBD-II port, turn on the ignition, and follow the scanner's instructions to erase the trouble codes. Alternatively, you can disconnect the car battery for about 15 minutes to reset the system, but this may also reset other electronic systems. Always ensure any underlying issues are resolved before clearing the light.
Type your answer here... On c230 kompressor 2000 while honding "0"buttom and turning the key to on without starting the car.
A Chilton can provide information on how to reset the scheduled maintenance advisory on a 1997 C230. If this isn't own then the owner's manual can assist in resetting the scheduled maintenance advisory.
turn the steering, full lock to the left, then full lock to the right, while being stationary, light will then go out.
you can reset with a programer made by snap-on tools it is called a motis programer
go to napa and buy the sensor for about $11.00.
Turn the key on and do not start the car. Hit the left and right buttons until the mileage is displayed and then hit the up and down buttons until the service light displays. Hold the reset button on the trip meter and hit it again to confirm the reset.
Replace the sensor
To reset the service indicator on 2003 Mercedes C230, turn on the ignition and scroll through the buttons on the steering wheel. Click on the next service due menu. Hold the adjustment knob on the left side of the cluster down, and hold for 5 seconds.
No. It has rear wheel drive.