If this is the 1.4 meridian version of the car year about 1998 then if you hold the trip counter reset button in for about 10 seconds the minute hand will begin to move around the clock face. Hope this help's.
You can set or adjust the clock on a Peugeot Boxer van by pushing on the little buttons below the clock using a pen point.
How do you tune in the radio on a Peugeot 107 Active
You can purchase a set of brake pads for a Peugeot 306 GTI online at the auction website eBay. You can also find parts for one at the AxleDirect website as well.
hold down reset trip button for a minute - takes a long time but changes time eventually
The dealer should be able to make a set from the VIN. The dealer should be able to make a set from the VIN.
SPARK PLUGS ARE NOW PRE SET AT MANUFACTURE. THE GAP SHOULD BE 0.7MM. BUY NEW ONES AND THEY ARE SET CORRECTLY.
To set the clock in a Peugeot 406, turn the ignition on without starting the engine. Press the "Menu" button on the dashboard until you see the clock display. Use the arrow buttons to adjust the hours and minutes, then confirm your settings. Finally, press the "Menu" button again to exit the setting mode.
There is no such thing as 'analog time'. Time is measured the same way whether you use an analog or digital clock. An analog clock is represented as a circle, with 'hands' on its face that point to different numbers to tell the time. A digital clock is simply a set of numbers, usually accompanied by 'AM' or 'PM' to denote day or night. For instance: 9:42 PM
Smash off with hammer n drift.. be carefully not to set of air bag
To set the analog clock, located at the top center of the instrument panel, press and hold the button (located just to the left of the clock on the silver bezel, at the "nine" o'clock position) in until the setting is correct. The clock will adjust slowly at first and then quicker the longer the button is held.
To change the clock in a Peugeot 106, first, turn on the ignition without starting the engine. Locate the clock adjustment buttons on the dashboard, usually found near the radio. Press the "H" button to adjust the hour and the "M" button for the minutes. Once set, the time will automatically save when you turn off the ignition.
assuming this is the digital clock, you hit the clock button on the dash, followed by the reset button followed by the clock button. at this point, you should be able to hit the clock button to advance numbers, and the reset button to change the numbers you are setting. if its the analog clock, pull on the knob and turn it