The service light comes on after a certain numbers of hours. I think around 200 hours. The indicator light lets you know you have just a few hours before the machine shuts off and has to be serviced. I think on the DD200 it is wired to the carbon brushes. Once they wear down to a certain point the light comes on. After that they wear down further until a pin pops out cutting power to the motor.
no reset switch in this system
A off
i have a megane scenic 2004 and just discovered that i can switch off passenger airbag by a switch in the dash , which you would see when opening the drivers door. Sorry don not know about service light.
unplug your car battery
For the service light, Switch ignition on, The display will flash for 2 seconds, press the button next to fuel gauge until "----" appeares in the display, Release the button and switch the ignition off, and that should reset the light for you,
According to the doblo operating guide you have to take it to a fiat dealer to switch off the service light. I also asked my mechanic and he confirms this.
In order to reset the service light on a 2000 reg Megan you\'ll need to start by turning the ignition switch to the "On" position without starting the engine. Once the service light appears on the dashboard you can reset it by following these steps: Press and hold the odometer reset button Turn the ignition switch to the "Off" position Release the odometer reset button Turn the ignition switch back to the "On" positionAfter following these steps the service light should reset and no longer appear on the dashboard.
go to your local garage they use a laptop program :)
The simplest answer is find a shop like halfords and purchase a service light resetting switch around £ 25.00. There is a a black round cap that you unscrew in the engine bay left side. You know when you have it as the pins when you remove the cap match the switch. Just follow the instructions with the switch.
You possibly have a shorted or broken switch on one of your doors. These work by earthing out when a door is openedThe manual dome light switch is on.More than likely it is the door switch. The switch is located in the door latch and the door panel must be removed to service.
To reset service ride control light on yukon detail one must use their manual to determine which button or switch is used to reset the control light properly.
To reset your service light --Get in the vehicle - ensure all doors are closed..The switch the Ign ON..Then press both the accelerator AND the brake pedal and HOLD them down for a minimum of 15 seconds -Then press the "OK" button ( in the centre of the little square toggle switch arrangement ) ...The service light will then go out when the system is reset..Release the pedals and switch the ign Off.Read more: http://www.justanswer.com/questions/22nwa-service-reset-on-a-mondeo-2-0-tdci-08-reg#ixzz0cUfHFN2n